Home
Class 12
PHYSICS
What is the value of inductance L for w...

What is the value of inductance L for which the current is a maximum in a series LCR circuit with `C= 10 muF` and w=`1000s^(-1)`

A

10 mH

B

100 mH

C

1 mH

D

cannot be calculated unless R is known

Text Solution

Verified by Experts

Promotional Banner

Topper's Solved these Questions

  • ELECTROMAGNETIC WAVES

    SARAS PUBLICATION|Exercise EXAMPLE|15 Videos

  • Electrostatics

    SARAS PUBLICATION|Exercise EXAMPLE|31 Videos

Similar Questions

Explore conceptually related problems

Obtain the resonant frequency omega of a series LCR circuit with L = 2.0 H, C = 32muF and R = 10 Omega . What is the Q-value of this circuit ?

A series LCR circuit with L = 0.12 H, C = 480 nF, R = 23Omega is connected to a 230 V variable frequency supply. a. What is the source frequency for which current amplitude is maximum? Obtain this maximum value. b. What is the source frequency for which average power absorbed by the circuit is maximum? Obtain the value of this maximum power. c. For which frequencies of the source is the power transferred to the circuit half the power at resonant frequency? What is the current amplitude at these frequencies? d. What is the Q-factor of the given circuit?

Obtain the resonant frequency and Q-factor of a series LCR circuit with L = 3.0 H, C = 27 muF , and R= 7.4Omega . It is desired to improve the sharpness of the resonance of the circuit by reducing its 'full width at half maximum' by a factor of 2. Suggest a suitable way.

What happens to the value of current in RLC series circuit, if the frequency of the source is increased?

In the circuit (Figure ) , the current it to be measured. What is the value of the current if the ammeter shown (a) is galvanometer with a resitance R_(G) = 60,00 Omega , (b) is a galvanometer by a shunt resitance r_(s) = 0.02 omega (c) is an ideal ammter with zero resitance ?

Two coils have amutual inductance 0.005 H. The current changes in the first coil according to the equation I= i_m sin omega t , where i_m = 10 A and w= 100 pi rad s^(-1) . The maximum value of the emf induced in the second coil is:

A sinusoidal voltage of peak value 283 V and frequency 50Hz is applied to a series LCR circuit in which R= 3 ohm L= 25.48mH C= 796 mu F. Suppose the frequency of the source can be varied. (a) What is the frequency of the source at which resonance occurs? (b) Calculate the impedance, the current, and the power dissipated at the resonant condition.

A capacitance C , a resistance R and an emf (epsilon) are connected in series at t=0.What is the maximum value of (a) the potential difference across the resistor, (b) the current in the circuit,(c )the potential difference across the capacitor, (d) the energy stored in the capacitor ,(e)the power delivered by the battery and (f) the power converted int heat.

The internal resistance of a 2.1 V cell which gives a current of 0.2A through a resistance of 10 Omega is

SARAS PUBLICATION-ELECTRONIC DEVICES-EXAMPLE
  1. What is the value of inductance L for which the current is a maximum ...

    Text Solution

    |

  2. A transformer is used to light a 100W and 110V lamp from 220V mains. I...

    Text Solution

    |

  3. A common emitter amplifier has voltage gain of 50, an input impedance ...

    Text Solution

    |

  4. In the following circuit, the output Y for all possible inputs A and B...

    Text Solution

    |

  5. A p-n photodiode is made of a material with ,band gap of 2.0 ev The mi...

    Text Solution

    |

  6. The circuit is equivalent to:

    Text Solution

    |

  7. The symbolic representation of four logic gates are given below: ...

    Text Solution

    |

  8. A p-n photodiode is farbricated from a semiconductor with a band gap o...

    Text Solution

    |

  9. The device that act as a complete electronic circuit is:

    Text Solution

    |

  10. In forward biasing of the p-n junction

    Text Solution

    |

  11. Symbolic represntation of four logic gates are shown as Pick out...

    Text Solution

    |

  12. The figure show a logic circuit with inputs A and B and the output C.T...

    Text Solution

    |

  13. C, Si and Ge have same lattice structure . Why is C an insulator while...

    Text Solution

    |

  14. For a CE- transistor amplifier , the audio signal voltage across the c...

    Text Solution

    |

  15. Two ideal diodes are connected to a battery as shown in the circuit .T...

    Text Solution

    |

  16. In a common emiter (CE) amplifier having a voltage gain G, the transis...

    Text Solution

    |

  17. The output (X) of the logic circuit shown in figure will be

    Text Solution

    |

  18. In an unbiased p-n junction , holes diffuse from the p-region to n- re...

    Text Solution

    |

  19. One way in which the operation of a-n-p-n transistor differs from that...

    Text Solution

    |

  20. The output from a NAND gate is divided into two in parallel and fed to...

    Text Solution

    |