Home
Class 12
PHYSICS
Two bulbs X and Y having same voltage ra...

Two bulbs `X` and `Y` having same voltage rating and of power 40 watt and 60 watt respectively are connected in series across a potential difference of 300 volt, then

A

X will glow brighter

B

Resistance of `Y` is greater than `X`

C

Heat produced in `Y` will be greater than `X`

D

Voltage drop in `X` will be greater than `Y`

Text Solution

Verified by Experts

The correct Answer is:
A

(a) Resistance `prop (1)/(power)`. Thus, `40 W` bulb has a high resistance. Because of which there will be more Potential drop across `40 W` bulb. Thus `40 W` bulb will glow brighter.
Promotional Banner

Topper's Solved these Questions

  • CURRENT ELECTRICITY

    A2Z|Exercise Problems Based On Mixed Concepts|34 Videos
  • CURRENT ELECTRICITY

    A2Z|Exercise Section - A|1 Videos
  • CURRENT ELECTRICITY

    A2Z|Exercise Potentiometer And Meter Bridge|45 Videos
  • ATOMIC PHYSICS

    A2Z|Exercise Section D - Chapter End Test|30 Videos
  • DUAL NATURE OF RADIATION AND MATTER

    A2Z|Exercise Section D - Chapter End Test|30 Videos

Similar Questions

Explore conceptually related problems

Two bulbs consume the same power when operated at 200 V and 300 V respectively. When these bulbs are connected in series across a DC source of 400 V, then the ratio of power consumed across them is

If two bulbs of power 60 W and 100 W respectively each rated 110 V are connected in series with the supply of 220 V, then

Two bulbs consume same energy when operated at 200 V and 300 V , respectively . When these bulbs are connected in series across a dc source of 500 V , then

A 25 watt, 220 volt bulb and a 100 watt, 220 volt bulb are connected in series across 440 volt line

Two bulbs consume same power when operated at "200V and "300V" respectively.When the bulbs are connected in series across a D.C source of "500V" then

Two bulbs 40W and 60W and rated voltage 240V are connected in series across a potential difference of 420V.The bulb which will work above its rated voltage is ----------W

What will happen when a 40 watt 220 volt lamp and 100 watt-220 volt lamp are connected in series across 40 volt supply?

A2Z-CURRENT ELECTRICITY-Heating Effect Of Current
  1. What will happen when a 40 watt 220 volt lamp and 100 watt-220 volt la...

    Text Solution

    |

  2. What should be the value of resistance R in the circuit shown in figur...

    Text Solution

    |

  3. The current in C is 2 A. The rate of heat of loss in A,B and C are 1.2...

    Text Solution

    |

  4. If the length of the filament of a heater is reduced by 10%, the power...

    Text Solution

    |

  5. Two wire A and B of same meterial and mass have their lengths in the r...

    Text Solution

    |

  6. Two bulbs X and Y having same voltage rating and of power 40 watt and ...

    Text Solution

    |

  7. In an electric circuit shown in the figure. The external resistance R ...

    Text Solution

    |

  8. The resistance of the filament of an electric bulb changes with temper...

    Text Solution

    |

  9. In the circuit shown in fig the heat produced in the 5 ohm resistor du...

    Text Solution

    |

  10. Water boils in an electric kettle in 15 minutes after switching on. If...

    Text Solution

    |

  11. The resistance of a heater coil is 110 ohm. A resistance R is connecte...

    Text Solution

    |

  12. An electric kettle takes 4 A current at 220 V. How much time will it t...

    Text Solution

    |

  13. Four identical electrical lamps are labelled 1.5 V, 0.5 A which descri...

    Text Solution

    |

  14. A 100 W bulb B1, and two 60 W bulbs B2 and B3 are connected to a 250 ...

    Text Solution

    |

  15. An electric bulb rated for 500 W at 100 V is used in a circuit having ...

    Text Solution

    |

  16. The wiring of a house has resistance 6 Omega A 100 W bulb is glowing. ...

    Text Solution

    |

  17. Electric bulb 50 W - 100 V glowing at full power are to be used in par...

    Text Solution

    |

  18. If a 30 V, 90 W bulb is to be worked on a 120 V line, resistance of h...

    Text Solution

    |

  19. For ensuring dissipation of same energy in all three resistors (R(1), ...

    Text Solution

    |

  20. Battery shown in figure has e.m.f. E and internal resistance r. Curren...

    Text Solution

    |