Home
Class 11
PHYSICS
When two ends of a rod wrapped with cott...

When two ends of a rod wrapped with cotton are maintained at differences and after some time every point of the rod attains a constant temperature, then

A

Condition of heat at different points of the rod stops becasuse the temperature is not increasing

B

rod is bad conductor of heat

C

heat is being radiated from each point of the rod

D

each point of the rod is giving heat to its neighbour at the same rate at which it is receving heat

Text Solution

Verified by Experts

The correct Answer is:
D
Doubtnut Promotions Banner Mobile Dark
|

Topper's Solved these Questions

  • HEAT TRANSFER

    CP SINGH|Exercise Exercises|94 Videos
  • HEAT AND CALORIMETRY

    CP SINGH|Exercise Exercise|37 Videos
  • KINETIC THEORY OF GASES

    CP SINGH|Exercise Exercises|79 Videos

Similar Questions

Explore conceptually related problems

The ends of a rod of uniform thermal conductivity are maintained at different (constant) temperatures. Afer the steady state is achieved:

A semicircular rods is joined at its end to a straight rod of the same material and the same cross-sectional area. The straight rod formss a diameter of the other rod. The junction are maintaine dat different temperature. Find the ratio of the heat transffered through a cross section of the straigh rod in a given time.

Knowledge Check

  • When two ends of a rod wrapped with cotton are maintained at different temperatures and after some time every point of the rod attains a constant temperature, then

    A
    Conduction of heat at different points of the rod stops because the temperature is not increasing
    B
    Rod is bad conductor of heat
    C
    Heat is being radiated from each point of the rod
    D
    Each point of the rod is giving heat to its neighbour at the same rate at which it is receiving heat
  • Two ends of area A of a uniform rod of thermal conductivity k are maintained at different but constant temperatures. At any point on the rod, the temperature gradient is (dT)/(dl) . If I be the thermal current in the rod, then:

    A
    `I prop A`
    B
    `I prop (dT)/(dl)`
    C
    `I prop A^(@)`
    D
    `I prop(1)/(((dT)/(dl))`
  • The two ends of uniform rod of thermal conductivity K are maintained at different but constant temperatre. The temperature gradient at any point on the rod is d theta // dx . The heat flow per unit time per unit cross-section of the rod is I . (i) (d theta)/(dx) is the same for all point on the rod (ii) I = K (d theta)/(dx)

    A
    (i) only
    B
    (ii) only
    C
    (i), (ii)
    D
    none
  • Similar Questions

    Explore conceptually related problems

    The ends of a copper rod of length 1m and area of cross-section 1cm^2 are maintained at 0^@C and 100^@C . At the centre of the rod there is a source of heat of power 25 W. Calculate the temperature gradient in the two halves of the rod in steady state. Thermal conductivity of copper is 400 Wm^-1 K^-1 .

    The two ends of a uniform rod of thermal conductivity k are maintained at different but constant temperatures. The temperature gradientat any point on the rod is (d theta)/(dl) (equal to the difference in temperature per unit length). The heat flow per unit time per unit cross-section of the rod is l then which of the following statements is/are correct:

    Three metal rods of the same material and identical in all respect are joined as shown in the figure. The temperatures at the ends are maintained as indicated. Assuming no loss of heat from the curved surface of the rods, the temperature at the junction X would be

    Two ends of a conducting rod of varying cross-section are maintained at 200^(@)C and 0^(@)C respectively. In steady state:

    Two ends of a conducting rod of varying cross-section are maintained at 200^(@)C and 0^(@)C respectively. In steady state: