Home
Class 12
PHYSICS
A tuned amplifier circuit is used to gen...

A tuned amplifier circuit is used to generate a carrier frequency of 2 MHz for the amplitude modulation. The value of `sqrt(LC)` is

A

`(1)/(2pi xx 10^(6))`

B

`(1)/(2xx10^(6))`

C

`(1)/(3pi xx10^(6))`

D

`(1)/(4pi xx 10^(6))`

Text Solution

Verified by Experts

The correct Answer is:
D

For transistor as an oscillator, `f=(1)/(2pi sqrt(LC))`
where, `f=2MHz =2xx10^(6)Hz and sqrt(LC)=?`
`rArr sqrt(LC)=(1)/(2pif)=(1)/(2pi xx 2xx10^(6))=(1)/(4pi xx 10^(6))`
Promotional Banner

Topper's Solved these Questions

  • SEMICONDUCTORS

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise MHT CET Corner|25 Videos
  • SEMICONDUCTORS

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise Exercise 1 ( TOPICAL PROBLEMS )|84 Videos
  • SCALARS AND VECTORS

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise Exercise 2 (Miscellaneous Problems)|20 Videos
  • STATIONARY WAVES

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise MHT CET Corner|28 Videos

Similar Questions

Explore conceptually related problems

The LC product of a tuned amplifier circuit require to generate a carrier wave of 1 MHz for amplitude modulation is

Compute LC product of a tuned amplifer circuit required to generate a carrier wve of 1 MHz for amplitude modulation

A speech signal of 3 kHz is used to modulate a carrier signal of frequency 1 MHz , using amplitude modulation. The frequencies of the side bands will be

A speech signal of 3 kHz is used to modulate a carrier signal of frequency 1 MHz, using amplitude modulation. The frequencies of the side bands will be

In amplitude modulation, carrier wave frequencies are:

A modulating wave of frequency 100 MHz and amplitude 100V is superimposed on a carrier wave of frequency 300 GHz and amplitude 400V . The value of modulating index and difference between the maximum frequency and minimum frequency of modulated wave are respectively :

In the given detector circuit, the suitable value of carrier frequency is

A message signal of frequency 12 kHz and peak voltage 12 volt is used to modulate a carrier of frequency 1 MHz and peak voltage 24 volt. What is the modulation index and the side bands produced ?

MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS-SEMICONDUCTORS-Exercise 1 ( MISCELLANEOUS PROBLEMS )
  1. In a common emitter transistor amplifier, the output resistance is 500...

    Text Solution

    |

  2. The current gain of a transistor in a common base arrangement in 0.98 ...

    Text Solution

    |

  3. A tuned amplifier circuit is used to generate a carrier frequency of 2...

    Text Solution

    |

  4. In a common-base amplifier, the phase difference between the input sig...

    Text Solution

    |

  5. In an n-p-n transistor circuit, the collector current is 9 mA. If 90% ...

    Text Solution

    |

  6. The circuit diagram (see fig.) shows a 'logic combination' with the st...

    Text Solution

    |

  7. The combination of gates shown below yields

    Text Solution

    |

  8. The input resistance of a silicon transistor is 100Omega base current ...

    Text Solution

    |

  9. Pure sodium (Na) is a good conductor of electricity because the 3s and...

    Text Solution

    |

  10. In a common base amplifier circuit, calculate the change in base curre...

    Text Solution

    |

  11. In the figure, potential difference between A and B is

    Text Solution

    |

  12. The circuit shown in the figure contains two diodes each with a forwar...

    Text Solution

    |

  13. The diode used in the circuit shown in the figure has a constant volta...

    Text Solution

    |

  14. In a common emitter amplifier, using output reisistance of 5000 ohm an...

    Text Solution

    |

  15. The length of a germanium rod is 0.58 cm and its area of cross-section...

    Text Solution

    |

  16. If a Zener diode (V(Z)=5 and I(Z)=10 mA) is connected in series with a...

    Text Solution

    |

  17. A red LED emits light of 0.1 watt uniformaly around it. The amplitude ...

    Text Solution

    |

  18. The circuit has two oppositively connected ideal diodes in parallel wh...

    Text Solution

    |

  19. A 2V battery is connected across AB as shown in the figure. The value ...

    Text Solution

    |

  20. The value of the resistor, R(S), needed in the dc voltage regulator ci...

    Text Solution

    |