Home
Class 12
PHYSICS
If E(0) is the peak emf , l(0) is the pe...

If `E_(0)` is the peak emf , `l_(0)` is the peak current and `phi` is the phase difference between them, then the average power dissipation in the circuit is

A

`(1)/(2)E_(0)l_(0)`

B

`(E_(0)l_(0))/(sqrt(2))`

C

`(1)/(2)E_(0)l_(0)sinphi`

D

`(1)/(2)E_(0)l_(0)cosphi`

Text Solution

Verified by Experts

The correct Answer is:
D
The average power dissipation in the circuit is `(1)/(2)E_(0)l_(0)cosphi`.
Promotional Banner

Topper's Solved these Questions

  • ELECTROMAGNETIC INDUCTION

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise Example 30|1 Videos

  • ELECTROMAGNETIC INDUCTION

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise MHT CET CONER|34 Videos

  • ELECTROMAGNETIC INDUCTION

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise Example 1|127 Videos

  • ELASTICITY

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise MHT CET CORNER|16 Videos

  • ELECTRONS AND PROTONS

    MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS|Exercise MHT CET CORNER|19 Videos

Similar Questions

Explore conceptually related problems

The phase difference between voltage and current in series L-C circuit is

When an AC source of emf e=E_(0) sin(100t) is connected across a circuit i in the circuit, the phase difference between the emf e and the current i in the circuit is observed to be (pi//4) , as shown in the diagram. If the circuit consists possibly only of R-C or R-L or L-C in series, find the relationship between the two elements

If V_0 and I_0 are the peak current and voltge across the resistor in a series L-C-R circuit, then the power dissipated in the circuit is (power factor =costheta)

A sinusoidal voltage of peak value 283 V and frequency 50 Hz is applied to a series LCR circuit in which R = 3 ohm , L = 25.48 mH and C = 796 mu F . Find (a) the impedance of the circuit (b) phase difference between the voltage across the source and current (c) the power dissipated in the circuit and (d) the power factor.

A pure inductance is connected to an AC source. What will be the phase difference between the current and the EMF in the circuit?

The power factor of an, ac circuit is 0.5 Phase , difference between voltage , and current in this circuit is

In resonant circuits, at resonance, the phase difference between current and emf is

A lamp consumes only 50% of peak power in an a.c. circuit. What is the phase difference between the applied voltage and the circuit current

The power factor of an AC circuit is 0.5 . What will be the phase difference between voltage and current in this circuit ?

MHTCET PREVIOUS YEAR PAPERS AND PRACTICE PAPERS-ELECTROMAGNETIC INDUCTION-Example 2
  1. In the circuit shown here, the point C is kept connected to the point ...

    Text Solution

    |

  2. Answer the following questions : (a) When a low flying aircraft pass...

    Text Solution

    |

  3. If E(0) is the peak emf , l(0) is the peak current and phi is the phas...

    Text Solution

    |

  4. A capacitor 50muF is connected to a power source V220sin50t (V in volt...

    Text Solution

    |

  5. The natural frequency of an LC- circuit is 1,25,000 cycles per second....

    Text Solution

    |

  6. The ratio of secondary to primary turns is 4:5. if power input is P, t...

    Text Solution

    |

  7. O is the centre of two coplanar concentric circular conductors, A and ...

    Text Solution

    |

  8. In an circuit, V and I are given by V=150sin(150t) V and I =150sin(150...

    Text Solution

    |

  9. Alternating current can not be measured by D.C. Ammeter because

    Text Solution

    |

  10. A bulb is connected first with DC and the then AC of same voltage then...

    Text Solution

    |

  11. The figure shows an experimental plot discharging of a capacitor in an...

    Text Solution

    |

  12. In an AC circuit, the current is given by i=5sin(100t-(pi)/2) and the ...

    Text Solution

    |

  13. In an AC circuit I=100sin 200pit. The time required for the current to...

    Text Solution

    |

  14. In a series resonant LCR circuit the voltage across R is 100 volts and...

    Text Solution

    |

  15. In the given circuit, the AC source has (omega) = 100 rad//s. Consider...

    Text Solution

    |

  16. A metal conductor of length 1m rotates vertically about one of its end...

    Text Solution

    |

  17. Energy required to establish a current of 4 A in a coil of self-induct...

    Text Solution

    |

  18. The maximum voltage in DC circuit is 282 V. the effective voltage in A...

    Text Solution

    |

  19. A generator produces a time varying voltage given by V=240 sin 120 t, ...

    Text Solution

    |

  20. An AC is given by the equation i=i(1)cos omegat+i(2)sin omegat. The r....

    Text Solution

    |