A wire elongastes by 1.0 mm when a load ...

A wire elongastes by 1.0 mm when a load W ils hung from it. If this wire goes over a pulley and two weights W each are hung at the two ends the elongation of the wire will be

`0.5m`

`1.0mm`

`2.0mm`

`4.0mm`

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

DAILY PRACTICE PROBLEMS
RESONANCE|Exercise dpp 89 illustration|5 Videos
DAILY PRACTICE PROBLEMS
RESONANCE|Exercise dpp 90 Illustration|2 Videos
DAILY PRACTICE PROBLEMS
RESONANCE|Exercise dpp 88|7 Videos
CURRENT ELECTRICITY
RESONANCE|Exercise Exercise|54 Videos
ELASTICITY AND VISCOCITY
RESONANCE|Exercise Advanced Level Problems|9 Videos

Similar Questions

Explore conceptually related problems

A wire elongates by l mm when a load W is hanged from it. If the wire goes over a pulley and two weights W each are hung at the two ends, the elongation of the wire will be (in mm)

A wire elongates by l units, when a load w is suspended from it . If the wirew gets over a pulley ( equally on both the sides ) and two weights w each are hung at the two ends, the elongation of wire (in units ) will be

When a weight W is hung from one end of a wire of length L (other end being fixed), the length of the wire increases by l . If the same wire is passed over a pulley and two weights W each are hung at the two ends,what will be the total elongation in the wire?

When a load W is hung from a wire, it extends by Deltal . The heat produced in the process is

A wire whose cross-sectional area is 2 mm^2 is stretched by 0.1 mm by a certain load, and if a similar wire of triple the area of cross-section is stretched by the same load, then the elongation of the second wire would be

When a load of 5kg is hung on a wire then extension of 30 cm take place then work done will be :-

A metal wire of length L is suspended vertically from a rigid support. When a bob of mass M is attached to the lower end of wire, the elongation of the wire is l:

One end of a uniform wire of length l and weight W is attached to a point in the roof and a weight W/2 is suspended from the lower end. If A is the area fo cross-section of the wire, then stress of the wire at its midpoint will be

When a load of 10 kg is hung from the wire, then extension of 2m is produced. Then work done by restoring force is

RESONANCE-DAILY PRACTICE PROBLEMS-Now answer the following :

A wire elongastes by 1.0 mm when a load W ils hung from it. If this wi...
Text Solution
|
The length of a metal wire is l(1) when the tension in it is T(1) and ...
Text Solution
|
A heavy mass is attached to a thin wire and is whirled in a vertical c...
Text Solution
|
Two wires of equal length and cross sectional area suspended as shown ...
Text Solution
|
A steel wire and a copper wire of equal length and equal cross- sectio...
Text Solution
|
A steel rod of cross sectional area 4cm^2 and length 2m shrinks by 0.1...
Text Solution
|
Consider the situation shown in figure. The force F is equal to the m2...
Text Solution
|
If in a wire of Young's moduls Y, longitudinal strain X is produced th...
Text Solution
|
A metal wire of length L is suspended vertically from a rigid support....
Text Solution
|
A metal wire of length L, area of cross-section A and young's modulus ...
Text Solution
|
Two wires of the same material and length but diameters in the ratio 1...
Text Solution
|
The workdone in increasing the length of a one metre long wire of cro...
Text Solution
|
One end of a long metallic wire of length (L) is tied to the ceiling. ...
Text Solution
|
In the figure shown the straing versus stress graph for two values of...
Text Solution
|
A metal square plate of 10cm side rests on 2mm thick caster oil layer....
Text Solution
|
A man starts rowing his stationary cuboidal boat of base area A=10m^(2...
Text Solution
|
As per the shown figure the central solid cylinder starts with initial...
Text Solution
|
A ball bearing of radius of 3mm made of iron of density 7.85g cm^(-3) ...
Text Solution
|
An air bubble of 1cm radius is rising at a steady rate of 0.5cms^(-1) ...
Text Solution
|
A metallic sphere of radius 1.0 xx 10^(-3) m and density 1.0 xx 10^(4)...
Text Solution
|