Home
Class 12
PHYSICS
In the circuit, E = 10 volt, R(1) = 5.0 ...

In the circuit, `E = 10` volt, `R_(1) = 5.0` ohm, `R_(2) = 10 `ohm and `L = 5.0 ` henry. The current just after the switch S is pressed is.

A

`2.0A`

B

`3.0A`

C

`5.0A`

D

`6.0A`

Text Solution

Verified by Experts

The correct Answer is:
A
Promotional Banner

Topper's Solved these Questions

  • DUAL NATURE OF MATTER AND RADIATION

    DISHA|Exercise Physics|30 Videos

  • ELECTROMAGNETIC WAVES

    DISHA|Exercise Physics|29 Videos

Similar Questions

Explore conceptually related problems

In the circuit shows in Fig. , E = 10 V , R_(1) = 5 Omega , R_(2) = 10 Omega , and L = 5 H . For the two separate conditions, (i) switch S is just closed and (ii) switch S is closed for a long time, calculate a. current i_(1) through R_(1) , b. current i_(2) through R_(2) , c. current i through the switchs, d. the potential difference across R_(2) , e. the potential difference across L , f. di_(2)//dt .

In the circuit given E = 6.0 V, R_(1) = 100 ohms, R_(2) = R_(3) = 50 ohms, R_(4) = 75 ohms . The equivalent resistance of the circuit, in ohms, is

In the circuit given E = 6.0 volt, R_(1) = 100Omega, R_(2) = R_(3)=50Omega and R_(4)=75Omega . The equivalent resistance of the circuit, in ohms is

In Fig. 30-41, E = 100 V, R_(1) = 10.0 Omega, R_(2) = 20.0 Omega , R_(3) = 31.0 Omega , and L = 2.00 H. Immediately after switch S is closed, what are (a) i_(1) and (b) i_(2) ? (Let currents in the indicated directions have positive values and currents in the opposite directions have negative values.) A long time later, what are (c) i_(1) and (d) i_(2) ? The switch is then reopened. Just then, what are (e) i_(1) and (f) i_(2) ? A long time later, what are (g) i_(1) and (h) i_(2) ?

In the given circuit E_1 = 3E_2 = 2E_3 = 6 volts R_1 = 2R_4 = 6ohms R_3 = 2R_2 = 4ohms C = 5 muf. Find the current in R and the energy stored in the capacitor.

For the circuit shown E=50 V R_(1)=10 Omega , R_(2)= 20 Omega, R_(3) = 30 Omega L = 2.0 mH . The current through R_(1) and R_(2) are ________ . And _______ immediate after the switch is closed.

In which of the following circuits is the current maximum just after the switch S is closed?

In a series LCR circuit X_L = 10 ohm , X_C = 4 ohm and R = 4 ohm. Find power factor.

Switch is closed at t = 0 then the current in the circuit at t = L/2R is

Find a potentail difference varphi_(1) - varphi_(2) between points 1 and 2 of the circuit shown in Fig if R_(1) 1= 10 Omega, R_(2) = 20 Omega, E_(1) = 5.0 V , and E_(2) = 2.0 V . The internal resisances of the current sources are negligible.

DISHA-ELECTROMAGNETIC INDUCTION-Physics
  1. A current of 5A is flowing at 220V in the primary coil of a transforme...

    Text Solution

    |

  2. An inductor (L = 100 mH), a resistor (R = 100Omega) and a battery (E =...

    Text Solution

    |

  3. which of ther following is constructed on the principle of electromagn...

    Text Solution

    |

  4. In the circuit, E = 10 volt, R(1) = 5.0 ohm, R(2) = 10 ohm and L = 5.0...

    Text Solution

    |

  5. Two inductors L(1) and L(2) are at a sufficient distance apart. Equiva...

    Text Solution

    |

  6. If the current in the primary coil is reduced from 3.0 ampere to zero ...

    Text Solution

    |

  7. A 50 Hz a.c. current of crest value 1A flows through the primary of a ...

    Text Solution

    |

  8. In an inductor of inductance L=100mH, a current of I=10A is flowing. T...

    Text Solution

    |

  9. A step up transformer has transformation ratio 5 : 3. What is voltage ...

    Text Solution

    |

  10. A step down transformer has turn ration 100//1. If secondary coil has ...

    Text Solution

    |

  11. A step-down transformer is used on a 1000 V line to deliver 20A at 120...

    Text Solution

    |

  12. Energy stored in an inductor is proportional to (i = current in the in...

    Text Solution

    |

  13. 1Voltage (r. m. s) in the secondary coil of a transformer depends upon...

    Text Solution

    |

  14. Large transformers, when used for some time, become hot and are cooled...

    Text Solution

    |

  15. In Fig. there is a conducting loop ABCDEF of resistance lambda per uni...

    Text Solution

    |

  16. In Fig. there is a conducting loop ABCDEF of resistance lambda per uni...

    Text Solution

    |

  17. In Fig. there is a conducting loop ABCDEF of resistance lambda per uni...

    Text Solution

    |

  18. Assertion: Soft iron is used as transformer core. Reason: Soft iron ...

    Text Solution

    |

  19. Assertion : An electric motor will have maximum efficiency when back e...

    Text Solution

    |

  20. Statement-1 : A transformer cannot work on dc supply. Statement-2 ...

    Text Solution

    |