A diode having potential difference 0.5 ...

A diode having potential difference `0.5 V` across its junction which does not depend on current, is connected in series with resistance of `20 Omega` across source. If `0.1A` passes through resistance then what is the voltage of the source?

1.5 V

2.0 V

2.5 V

5 V

Text Solution

Verified by Experts

Topper's Solved these Questions

RAY OPTICS AND OPTICAL INSTRUMNTS
DISHA|Exercise PHYSICS|44 Videos
SYSTEM OF PARTICLES AND ROTATIONAL MOTION
DISHA|Exercise PHYSICS|45 Videos

Similar Questions

Explore conceptually related problems

A p-n junction in series with a resistance of 5 kOmega is connected across a 50 V DC source . If the forward bias resistance of the junction is 50 Omega , the forward bias current is

A p-n junction diode has a forward bias resistance of 10 Omega and a reverse bias resistance of 10 k Omega . It is connected in series with a resistance of 990 Omega and a.d.c. source of 5V in such a way that the negative terminal of the source is connected to then region of the p-n junction. What is the current flowing in the circuit?

A coil having an inductance of 1//pi henry is connected in series with a resistance of 300 Omega . If 20 volt from a 200 cycle source are impressed across the combination, the value of the phase angle between the voltage and the current is :

The potential difference across terminals of cell of 20 V and r = 2 Omega connected to 8 Omega external resistance is

Current P through a certain non-metallic rod is given as i_(0)=0.2V^((3)/(2)) where V is potential difference across it. The rod is connected in series with a resistance to a 12 volt ideal bettery. What should be resistance ( in Omega ) so that power dissipated in the resistance is twice that of rod.

An alternating current of rms value 5A, passes through a resistance of 24 Omega . What is the maximum P.D. across the resister?

An ac source is connected across a resistance of 10 Omega The power dissipated in the resistor is 100W The rms valuse of the current and voltge are .

In an electric circuit, potential difference across a lamp is 20 V and current through the lamp is 0.5A. The resistance of the lamp is

DISHA-SEMICONDUCTOR-PHYSICS

Transfer characterstics [output voltage (V(o)) vs. input voltage (V(i)...
Text Solution
|
A half-wave rectifier is being used to rectify an alternating voltage ...
Text Solution
|
A diode having potential difference 0.5 V across its junction which do...
Text Solution
|
In common emitter amplifier, the current gain is 62. The collector res...
Text Solution
|
On doping germanium with donor atoms of density 10^(17) cm^(-3), find ...
Text Solution
|
The voltage gain of an amplifier with 9% negative feedback is 10. The ...
Text Solution
|
A system of four gates is set up as shown. The 'truth table' correspon...
Text Solution
|
The intrinsic conductivity of germanium at 27^(@) is 2.13 mho m^(-1) a...
Text Solution
|
The logic circuit shown below has the input waveforms ‘A’ and ‘B’ as s...
Text Solution
|
Pure Si at 500K has equal number of electron (n(e)) and hole (n(h)) co...
Text Solution
|
Which of the following statements is incorrect?
Text Solution
|
The relation between number of free electrons (n) in a semiconductor a...
Text Solution
|
If a PN junction diode of depletion layer width W and barrier height V...
Text Solution
|
The circuit has two oppositively connected ideal diodes in parallel wh...
Text Solution
|
For a transistor ampliflier in common emiter configuration for load im...
Text Solution
|
A PN - junction has a thickness of the order of
Text Solution
|
A working transitor with its three legs marked P, Q and R is tested us...
Text Solution
|
If a p-n junction diode, a square input signal of 10 V is applied as s...
Text Solution
|
When N-type of semiconductor is heated
Text Solution
|
The ratio of electron and hole currents in a semiconductor is 7/4 and ...
Text Solution
|