Home
Class 12
PHYSICS
The cut-in voltage for silicon diode is ...

The cut-in voltage for silicon diode is approximately

A

0.2 V

B

0.6 V and 0.9 V

C

1.1 V

D

1.4 V

Text Solution

Verified by Experts

The correct Answer is:
B
Promotional Banner

Topper's Solved these Questions

  • SEMICONDUCTORS

    BANSAL|Exercise Exercise-4 Section-B|6 Videos

  • SEMICONDUCTORS

    BANSAL|Exercise CBSE Question|32 Videos

  • SEMICONDUCTORS

    BANSAL|Exercise Exercise-3|24 Videos

  • MASTER PRACTICE PROBLEM

    BANSAL|Exercise Additional topic|70 Videos

  • TEST PAPERS

    BANSAL|Exercise PHYSICS PART C|14 Videos

Similar Questions

Explore conceptually related problems

The characteristic curve for a diode is shown in the figure for forward bias mode. The cut-off voltage for this diode is approximately-

The cut-in voltage of a germanium diode is approximately equal to

Shown below is a graph of current versus applied voltage for a diode . Approximately , what is the resistance of the diode for an applied voltage of – 1 V ?

Assuming that the silicon diode (having negligible resistance) the current through the diode is (knee voltage of silicon diode is 0.7V )

The reading of the ammeter for a silicon diode in the given circuit is :

The reading of the ammeter for a silicon diode in the given circuit is :

A sinusoidal voltage of peak value 200 volts is connected to a diode and resistor R in the circuit shown so that half wave rectification occurs. If the forward resistance of the diode is negligible compared to R the rms voltage (in volt) across R is approximately

The reading of an ammeter for a silicon diode in the given circuit is

The values of v and I for silicon diode is given as follows Using the data calculate the forward and reverse bias resistance of silicon diode

The diode shown in the circuit is a silicon diode. The potential difference between the points A and B will be

BANSAL-SEMICONDUCTORS-Exercise-4
  1. The energy gap separating valence band from a conduction band is 0.7 e...

    Text Solution

    |

  2. A transistor is connected in commono emitter configuration. The collec...

    Text Solution

    |

  3. The cut-in voltage for silicon diode is approximately

    Text Solution

    |

  4. A transistor have a beta a equal to 80 has a change in base current of...

    Text Solution

    |

  5. The edge of a cube is a=1.2xx10^(-2) m. Then its volume will be record...

    Text Solution

    |

  6. In a vernier callipers, n divisions of its main scale match with (n+1)...

    Text Solution

    |

  7. A wire has a mass 0.3+-0.003g, radius 0.5+-0.005mm and length 6+-0.06c...

    Text Solution

    |

  8. In Searle's experiment, the diameter of the wire as measured by a scre...

    Text Solution

    |

  9. The pitch of a screw gauge is 1 mm and there are 100 division on the c...

    Text Solution

    |

  10. Draw the circuit for experimental verification of Ohm's law using a so...

    Text Solution

    |

  11. An unknown resistance X is to be determined using resistances R1, R2 o...

    Text Solution

    |

  12. In a resonance column method, resonance occurs at two successive level...

    Text Solution

    |

  13. The side of a cube is measured by vernier callipers (10 divisions of a...

    Text Solution

    |

  14. Graph of position of image vs position of point object from a convex l...

    Text Solution

    |

  15. In a screw gauge, the zero of mainscale coincides with fifth division ...

    Text Solution

    |

  16. A student performs an experiment for determination of g [ = ( 4 pi^(2...

    Text Solution

    |

  17. In an experiment to determine the focal length (f) of a concave mirror...

    Text Solution

    |

  18. Some physical quantities are given in Column I and some possible SI un...

    Text Solution

    |

  19. A student performs an experiment to determine the Young's modulus of a...

    Text Solution

    |

  20. Student I ,II , and III perform an experiment for measuring the accele...

    Text Solution

    |