Home
Class 11
PHYSICS
A composite metal bar of uniform section...

A composite metal bar of uniform section is made up of length 25 cm of copper, 10 cm of nickel and 15 cm of aluminium. Each part being in perfect thermal contact with the adjoining part. The copper end of the composite rod is maintained at `100^(@)"C"` and the aluminium end at `0^(@)"C"`. The whole rod is covered with belt so that there is no heat loss occurs at the sides. If `K_(Cu) = 2K_(Al)" and" " K"_(Al) = 3"K"_(Ni)`, then what will be the temperatures of `Cu- Ni` and `Ni -Al` junctions respectively

A

`23.33^(@)C` and `78.8^(@)C`

B

`83.33^(@)C` and `20^(@)C`

C

`50^(@)C` and `30^(@)C`

D

`30^(@)C` and `50^(@)C`

Text Solution

Verified by Experts

The correct Answer is:
B
Promotional Banner

Topper's Solved these Questions

  • TRANSMISSION OF HEAT

    ERRORLESS |Exercise Graphical Questions|17 Videos

  • TRANSMISSION OF HEAT

    ERRORLESS |Exercise Assertion & Reason|24 Videos

  • TRANSMISSION OF HEAT

    ERRORLESS |Exercise Radiation (Newton s Law of Cooling)|37 Videos

  • THERMOMETRY, THERMAL EXPANSION AND CALORIMETRY

    ERRORLESS |Exercise Self Evaluation Test|15 Videos

  • UNITS, DIMENSION & MEASUREMENTS

    ERRORLESS |Exercise All Questions|333 Videos

Similar Questions

Explore conceptually related problems

The end A of rod AB of length 1 m is maintained at 80^(@) C and the end B at 0^(@) C. The temperature at a distance of 60 cm from the end A is

The ends of a metre stick are maintained at 100^(@)C and 0^(@)C . One end of a rod is maintained at 25^(@)C . Where should its other end be touched on the metre stick so that there is no heat current in the rod in steady state?

The ends of a metre stick are maintain at 100^(@)C and 0^(@)C . One end of a rod is mainntained 25^(@)C . Where should its other end be touched on the metre stick so that there is no heat current in the rod in steady state?

A large cylindrical rod of length L is made by joining two identical rods of copper and steel of length ((L)/(2)) each. The rods are completely insulated from the surroundings. If the free end of copper rod is maintained at 100^(@)C and that of steel at 0^(@)C then the temperature of junction is (Thermal conductivity of copper is 9 times that of steel)

One face of a copper cube of edge 10 cm is maintained at 100^(@)C and the opposite face is maintained at 0^(@)C . All other surfaces are covered with an insulating material. Find the amount of heat flowing per second through the cube. Thermal conductivety of copper is 385Wm^(-1) ^(@)C^(-1) .

On heating one end of a rod the temperature of the whole rod will be uniform when .

A composite rod of uniform cross-section has copper and aluminium sections of the same length in good thermal contact. The ends of the rod, which is well-lagged, are maintained at 100^(@)C and at 0^(@)C as shown in the diagram (Figure-4.33). The thermal conductivityof copper is twice that of aluminium. Which one of the following graphs represents the variation of temperature T with x along the rod in the steady state ?

A composite rod consists of a steel rod of length 25 cm and area 2A and a copper rod of length 50 cm and area A . The composite rod is subjected to an axial load F . If the Young's moduli of steel and copper are in the ratio 2: 1 then

Three rods of copper, brass and steel are joined together to form T shape as shown in figure. The cross sectional area of each rod is 4cm^(2) the end of copper rod is maintained at 10^(@)C and the ends of brass and steel rods at 0^(@)C assume there is no loss of heat to surrounding. What is temperature of junction point A in .^(@)C

ERRORLESS -TRANSMISSION OF HEAT-Critical Thinking
  1. A room at 20^@C is heated by a heater of resistence 20 ohm connected t...

    Text Solution

    |

  2. There is formation of layer of snow x cm thick on water, when the temp...

    Text Solution

    |

  3. A composite metal bar of uniform section is made up of length 25 cm of...

    Text Solution

    |

  4. Three rods of identical cross-sectional area and made from the same me...

    Text Solution

    |

  5. The only possibility of heat flow in a thermos flask is through its co...

    Text Solution

    |

  6. A sphere a cube and thin circular plate, all made of the same material...

    Text Solution

    |

  7. Two identical conducting rods are first connected independently to two...

    Text Solution

    |

  8. A solid cube and a solid sphere of the same material have equal surfac...

    Text Solution

    |

  9. Two bodies A and B have thermal emissivities of 0.01 and 0.81 respecti...

    Text Solution

    |

  10. A black body is at a temperature of 2880 K. The energy of radiation em...

    Text Solution

    |

  11. A black metal foil is warmed by radiation from a small sphere at tempe...

    Text Solution

    |

  12. Three rods of same dimensions are arranged as shown in Fig. They have ...

    Text Solution

    |

  13. Two metallic spheres S1 and S2 are made of the same material and have ...

    Text Solution

    |

  14. Three discs, A, B and C having radii 2m, 4m and6m respectively are coa...

    Text Solution

    |

  15. The total energy radiated from a block body source at constant tempera...

    Text Solution

    |

  16. A solid sphere and a hollow sphere of the same material and of equal r...

    Text Solution

    |

  17. A solid copper cube of edges 1 cm is suspended in an evacuated enclosu...

    Text Solution

    |

  18. A body initially at 80^(@)" C" cools to 64^(@)" C" in 5 minutes and to...

    Text Solution

    |

  19. A 5 cm thick ice block is there on the surface of water in a lake. The...

    Text Solution

    |

  20. A square is made of four rods of same material one of the diagonal of ...

    Text Solution

    |