Home
Class 11
PHYSICS
An open cubical tank completely filled w...

An open cubical tank completely filled with water is kept on a horizontal surface. Its acceleration is then slowly increasesd to `2m//s^(2)` as shown in the figure. The side of the tank is 1m. Find the mass of water that would spill out of the tank.

Text Solution

Verified by Experts

The correct Answer is:
[100 kg]
Promotional Banner

Topper's Solved these Questions

  • FLUID MECHANICS

    PHYSICS GALAXY - ASHISH ARORA|Exercise Advanced MCQ with one or more options correct|18 Videos

  • GRAVITATION

    PHYSICS GALAXY - ASHISH ARORA|Exercise Unsolved Numerical|94 Videos

Similar Questions

Explore conceptually related problems

A closed rectangular tank is completely filled with water and is accelerated horizontally with an acceleration towards the righ. Pressure is i. maximum and ii. minimum at

An open cubical tank was initially fully filled with water. When the tank was accelerated on a horizontal plane along one of its side it was found that one thrid of volume of water was spilled out. The acceleration was

A tank with base area L^2 is filled with a liquid to height H. The tank is acceleration horizontally with acceleration a as shown in figure. If a small hole is made at the point A. then it is observed that the liquid does not come out of the tank. The magnitude of acceleration should be

A vertical tank, open at the top, is filled with a liquid and rests on a smooth horizontal surface. A small hole is opened at the centre of one side of the tank. The area of cross-section of the tank is N times the area of the hole, where N is a large number. Neglect mass of the tank itself. The initial acceleration of the tank is

A spherical tank of 1.2 m radius is half filled with oil of relative density 0.8 . If the tank is given a horizontal acceleration of 10 m//s^(2) , the maximum pressure on the tank is sqrt(2P) pascal. Find the value of P .

A flat bottomed metal tank filled with water is dragged along a horizontal floor at the rate of 20 m//s The tank is of mass 100 kg and contains 900 kg of water and all the heat produced in the dragging is conducted to the water through the bottom plate of the tank. If the bottom plate has an effective area of conduction 1m^(2) and thickness 5 cm and the temperature of water in the tank remains constant at 50^(@) C, calculate the temperature of the bottom surface of the tank. Given the coefficient of friction between the tank and the floor is 0.5 and K for the material of the tank is 100 J//m sec K.

A large tank is filled with water to a depth of 15 m . A spout located 10.0 m above the bottom of the tank is then opened as shown in the figure . With what speed will water emerge from the spout ?

An open tank of cross sectional area A contains water up to height H. It is kept on a smooth horizontal surface. A small orifice of area A_(0) is punched at the bottom of the wall of the tank. Water begins to drainout. Mass of the empty tank may be neglected. (i) Prove that the tank will move with a constant acceleration till it is emptied. Find this acceleration. (iii) Find the find speed acquired by the tank when it is completely empty.

A storage tank is in the form of a cube.When it is full of water,the volume of the water is 15.625m^(3). If the present depth of the water is 1.3m, find the volume of water already used from the tank.

PHYSICS GALAXY - ASHISH ARORA-FLUID MECHANICS-Unsolved Numerical Problems
  1. Shows a hydraulic press with the larger piston of diameter 35cm at a h...

    Text Solution

    |

  2. Two identical cyclindrical vessels (area of cross section 3.5 xx 10^(-...

    Text Solution

    |

  3. An open cubical tank completely filled with water is kept on a horizon...

    Text Solution

    |

  4. A vertical U-tube of uniform inner cross-section contains mercury in ...

    Text Solution

    |

  5. Water flows through the tubes shown in figure. The areas of cross-sect...

    Text Solution

    |

  6. A person can change the volume of his body by taking air into his lung...

    Text Solution

    |

  7. A vessel contains oil (density =13.6 gm//cm^3). A uniform sphere float...

    Text Solution

    |

  8. The tension in a string holding a solid block below the surface of a l...

    Text Solution

    |

  9. A J-tube, shown in figure, contains a volume V of dry air trapped in a...

    Text Solution

    |

  10. A block of ice with an area A and a height h floats in water of densit...

    Text Solution

    |

  11. A solid ball of density half that of water falls freely under gravity ...

    Text Solution

    |

  12. A U-tube containing a liquid is accelerated horizontally with a consta...

    Text Solution

    |

  13. The tank in figure discharges water at constant rate for all water lev...

    Text Solution

    |

  14. The time period of a sample pendulum is T. Now the bob is immersed in ...

    Text Solution

    |

  15. A rubber ball of mass m and radius r is submerged in water to a depth ...

    Text Solution

    |

  16. A cubical vessel of height 1 m is full of water. What is the workdone ...

    Text Solution

    |

  17. A tank is filled with water to a height H. A hole is punched in the wa...

    Text Solution

    |

  18. A large block of ice 5 m thick has a vertical hole drilled through it ...

    Text Solution

    |

  19. A rectangular container of water undergoes constant acceleration down ...

    Text Solution

    |

  20. An iron casting containing a number of cavities weight 6000N in air an...

    Text Solution

    |