In a meter bridge set up, which of the following should be the properties of the one meter long wire?
A
High resistivity and low temperature coefficient
B
Low resistivity and low temperature coefficient
C
Low resistivity and high temperature coefficient
D
High resistivity and high temperature coefficient
Text Solution
Verified by Experts
The correct Answer is:
A
Topper's Solved these Questions
GENERAL PHYSICS
DC PANDEY|Exercise MCQ_TYPE|17 Videos
GENERAL PHYSICS
DC PANDEY|Exercise MATCH THE COLUMN|6 Videos
FLUID MECHANICS
DC PANDEY|Exercise Medical entranes gallery|49 Videos
GRAVITATION
DC PANDEY|Exercise (C) Chapter Exercises|45 Videos
Similar Questions
Explore conceptually related problems
Shown in the figure below is a meter- bridge set up will null deflection in the galvanometer. The value of the unknown resistor R is
A meter-bridge is based on the principle of
In a meter bridge the null point is obtained at the middle point of the wire. If in one gap the resistance is 10 Omega , then the value of resistance in the other gap is :–
Meter Bridge |Question practice
Meter Bridge|Questions
In a meter bridge, the length of the wire is 100 cm. At what position will the balance point be obtained if the two resistances are in the ratio 1:3?
When two known resistance R and S are connected in the left and right gaps of a meter bridge, the balance point is found at a distance l_(1) from the zero end of the meter bridge wire. An unknown resistance X is now connected in parallel to the resistance S and the balance point is found at a distance l_(2) from the zero end of the meter bridge wire, Obtain a formula for X in terms of l_(1), l_(2) and S.
