The currect voltage relation of diode is...

The currect voltage relation of diode is given by `1=(e^(1000 V//T)-1) mA`, where the applied voltage V is in volt and the temperature T is in degree Kelvin. If a student makes an error measuring `+-0.01 V` while measuring the current of `5 mA` at `300 K`, what will be error in the value of current in mA?

0.5 mA

0.05 mA

0.2 mA

0.02 mA

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

SEMI CONDUCTOR AND LOGIC GATES
MOTION|Exercise EXERCISE 2|33 Videos
ROTATIONAL MOTION
MOTION|Exercise Exercise - 3 ( Section-B )|24 Videos
SIMPLE HARMONIC MOTION
MOTION|Exercise EXERCISE -3 Section - B Previous Year Problems | JEE MAIN|23 Videos

Similar Questions

Explore conceptually related problems

The currect voltage relation of a diode is given by 1 = (e^(van v//T) -1 )mA where the applied volied V is in volts and the tempetature T is in degree kelvin if a student make an error meassurting +- 01 V while measuring the current of 5 mA at 300 K what be the error in the value of current in mA

The relation of voltage with current in a diode is expressed as below V=(1000 In (I+1))/(T) where v is the applied voltage in volts T is the temperature in degree kelvin and I is the current in milli amperes while measuring a current of 10 mA at T=300 k a student makes an error of pm 0.01 V calculate the error in the value of current in mA

The plate current in a diode is 20 mA when the plate voltage is 50 V or 60 V . What will be the current if the plate voltage is 70 V ?

The voltage supplied to a circuit is given by V=V_(0)t^(3/2) , where t is time in second. Find the rms value of voltage for the period, t=0 to t=1s.

The change in current through a junction diode is 1.2 mA when the forward bias voltage is changed by 0.6 V. The dynamic resistance is

In the experiment of verification of Ohm's law the error in the current measurement is 1%, while that in the voltage measurement is 2%. The error in the resistance has a maximum value of

MOTION-SEMI CONDUCTOR AND LOGIC GATES-EXERCISE 3

If the ratio of the concentration of electron to that of holes in a se...
Text Solution
|
A solid which is not transperent to visible light and whose conductivi...
Text Solution
|
In a common base mode of transistor, collector current is 5.488 mA for...
Text Solution
|
If the lattice constant of this semiconductor is decreased, then which...
Text Solution
|
In the following, which one of the diodes is reverse biased ?
Text Solution
|
The circuit has two oppositely connected ideal diodes in parallel. Wha...
Text Solution
|
If an a p-njunction, a square input signal of 10V is applied, as shown...
Text Solution
|
Carbon , silicon and germanium have four valence electrons each . At r...
Text Solution
|
A working transitor with its three legs marked P, Q and R is tested us...
Text Solution
|
In the circuit below, A and B represent two inputs and C represents th...
Text Solution
|
A p-n junction (D) shown in the figure can act as a rectifier. An alte...
Text Solution
|
The logic circuit shown below has the input waveforms ‘A’ and ‘B’ as s...
Text Solution
|
The combination of gates shown below yields
Text Solution
|
Truth table for system of four NAND gates as shown in figure is
Text Solution
|
The currect voltage relation of diode is given by 1=(e^(1000 V//T)-1) ...
Text Solution
|
The forward biased diode connection is
Text Solution
|
The temperature dependence of resistance of Cu and undoped Si in the t...
Text Solution
|
Identify the semiconductor devices whose characteristics are given bel...
Text Solution
|
If (i), (ii), (iii), (iv) are inputs to a gate and x is output, then a...
Text Solution
|
For a common emitter configuration if alpha and beta have their usual ...
Text Solution
|