Home
Class 12
PHYSICS
The length of a potentiometer wire requi...

The length of a potentiometer wire required to balance the e.m.f of cell (A) is 60cm. The length of the same wire under the same conditions required to balance the e.m.f of cell (B) is 45cm. If the e.m.f of cell (B) is 3.0 volts , the e.m.f of cell (A) is –

A

2.25 V

B

2.5 V

C

4.0 V

D

4.5 V

Text Solution

Verified by Experts

The correct Answer is:
C
Promotional Banner

Topper's Solved these Questions

  • Electrical Instrument

    MOTION|Exercise EXERCISE -3|16 Videos
  • Electrical Instrument

    MOTION|Exercise EXERCISE -1|43 Videos
  • ELASTICITY AND THERMAL EXPANSION

    MOTION|Exercise Exercise - 4 (Level-II)|11 Videos
  • ELECTRO MAGNETIC INDUCTION

    MOTION|Exercise EXERCISE-4| Section B (Prevous Years Problems )|29 Videos

Similar Questions

Explore conceptually related problems

The e.m.f. of a cell is a

The e.m.f. of a cell is always

The e.m.f. of a cell depends on

The e.m.f. of a cell is independent of

E.m.f. of a cell is measured in

How is DeltaG related to e.m.f. of the cell ?

125 cm of potentiometer wire balances the emf. of a cell and 100 cm of the wire is required for balance, if the poles of the cell are joined by a 2 Omega resistor. Then the internal resistance of the cell is

In a potentiometer a cell of emf 1.5 V gives a balanced point at 32 cm length of the wire. If the cell is replaced by another cell then the balance point shifts to 65 cm. Then the emf of second cell is

The e.m.f. of two cells can be compared by

MOTION-Electrical Instrument -EXERCISE -2
  1. The deflection in a moving coil galvanometer is reduced to half, when ...

    Text Solution

    |

  2. To send 10% of the main current through a moving coil galvanometer of ...

    Text Solution

    |

  3. In the given potentiometer circuit length of the wire AB is 3 m and re...

    Text Solution

    |

  4. A potentiometer wire 10 m long has a resistance 40ohms. It is put in s...

    Text Solution

    |

  5. The length of a potentiometer wire required to balance the e.m.f of ce...

    Text Solution

    |

  6. In figure, AB is a potentiometer wire, length 10 m and resistance 2 Om...

    Text Solution

    |

  7. A potentiometer experiment is setup as shown in fig. If both the galva...

    Text Solution

    |

  8. A cell of emf (E) and internal resistance (r) is balanced across (l) l...

    Text Solution

    |

  9. In a potentiometer arrangement shown in fig. The balancing length for ...

    Text Solution

    |

  10. The resistivity of a potentiometer wire is 40xx10^(-8)Omega-m and its ...

    Text Solution

    |

  11. A battery of emf 26V and internal resistance 0.4 ohm is connected to ...

    Text Solution

    |

  12. A cell of two volt and 1.5 ohm internal resistance is connected to two...

    Text Solution

    |

  13. Three wires are connected in series having resistances 2 , 3 and 5 ohm...

    Text Solution

    |

  14. A ten meter long potentiometer wire is connected to accumulator of emf...

    Text Solution

    |

  15. In an experiment to measure the internal resistance of a cell by a pot...

    Text Solution

    |

  16. Statement I : Potentiometer is based on wheatstone bridge. Statem...

    Text Solution

    |

  17. Statement I : Material used in the construction of a standard resista...

    Text Solution

    |

  18. Statement -1 : A potentiometer of longer length is used for accurate m...

    Text Solution

    |

  19. Assertion : The e.m.f. of the drivercell in the potentiometer experime...

    Text Solution

    |

  20. Statement I : If galvanometer is converted into an ammeter and milli...

    Text Solution

    |