Home
Class 11
PHYSICS
A thin liquid film formed between a U-sh...

A thin liquid film formed between a U-shaped wire and a light slider supports a weight of `1.5xx10^(-2)N`. The length of the slider is 30 cm and its weight is negligible. The surface tension of the liquid film is:

A

0.0125 `Nm^(-1)`

B

0.025 `Nm^(-1)`

C

0.1 `Nm^(-1)`

D

0.05 `Nm^(-1)`

Text Solution

Verified by Experts

The correct Answer is:
B

`{:("Force of"),("surface tension"):}}="weight on slider"`
`2Tl=W`
`therefore" "T=(W)/(2l)=(1.5xx10^(-2)N)/(2xx0.30m)`
`=0.025Nm^(-1)`
Promotional Banner

Topper's Solved these Questions

  • PROPERTIES OF MATTER

    PREMIERS PUBLISHERS|Exercise OTHER IMPORTANT QUESTION & ANSWERS ( VERY SHORT ANSWER QUESTIONS )|36 Videos
  • PROPERTIES OF MATTER

    PREMIERS PUBLISHERS|Exercise OTHER IMPORTANT QUESTION & ANSWERS (SHORT ANSWER QUESTIONS )|48 Videos
  • PROPERTIES OF MATTER

    PREMIERS PUBLISHERS|Exercise EVALUTION TEXTBOOK QUESTIONS & ANSWERS (NUMERICAL PROBLEMS )|20 Videos
  • OSCILLATIONS

    PREMIERS PUBLISHERS|Exercise OTHER IMPORTANT QUESTIONS & ANSWERS ( CONCEPTUAL QUESTIONS.)|24 Videos
  • QUESTION PAPER MARCH 2019

    PREMIERS PUBLISHERS|Exercise Part- IV|23 Videos

Similar Questions

Explore conceptually related problems

A U-shaped wire is dipped in a soap solution and removed. The thin soap film formed between the wire and the light slider supports a weight of 1.5 x 10-2 N (which includes the small weight of the silder). The length of the silder is 30 cm. What is the surface tension of the film ?

A rectangular film of liquid is extended from (4cmxx2cm) to (5cmxx4cm) .If the work done is 3xx10^-4 J, the value of the surface tension of the liquid is :

Water rises in a capillary tube to a certain height such that the upward force due to the durface tension is balanced by 62.84 xx 10^(-5)N force due to the weight of the liquid column. If the surface tension of water is 70 xx 10^(-3) Nm the radius of the capillary tube is

A light wire AB of length 10 cm can slide on a vertical frame as shown in figure. There is a film of soap solution trapped between the frame and the wire. Find the load W that should be suspended from the wire to keep it in equilibrium. Neglect friction. Surface tension of soat solution =25 dyne cm^-1 . Take g=10 ms^-2

A wire forming a loop is dipped into soap solution and taken out so that a film of soap solution is formed. A loop of 6.28 cm long thread is gently put on the film and the film is pricked with a needle inside the loop. The thread loop takes the shape of a circle. Find the tension in the thread. Surface tension of soap solution =0.030Nm^-1 .

An ideal monatonic gas is confined in a cylinder by a spring-loaded piston of cross section 8.0xx10^(-3) m^(2). initially the gas is at 300K and occupies a volume of 2.4xx10^(-3)m^(-3) and the sprinng is in its relaxed state. The gas is heated by a small heater until the piston moves out slowly by 0.1m. Calculate the final tempreture of the gas. The force constant if the spring is 8000Nm^(-1) ,and the atmospheric pressure is 1.0xx10^(5)Nm^(-2) . the cylinder and the piston are thermally insulated. The piston and the spring are massless and there is no friction between the piston and the cylinder. Neglect any heat-loss through the lead wires of the heater. The heat capacity of the heater coil is negligible. assume the spring to be massless

A bicycle is resting on its stand in the east - west direction and the rear wheel is rotated at an angular speed of 100 revolutions per minute. If the length of each spoke is 30.0 cm and the horizontal comonet of the earth's magnetic field is 2.0 X 10^(-5) T , find the emf induced between the axis and the outer end of a spoke. Neglect centripetal force acting on the free electrons of the spoke.

The capillaries shown in figure have inner radii 0.5 mm, 1.0 mm and 1.5 mm respectively. The liquid in the beaker is water. Find the heights of water level in the capillaries. The surface tension of water is 7.5xx10^-2Nm^-1 .

Figure shows an aluminium wire of length 60 cm joined to a steel wire of length 80 cm and stretched between two fixed supports. The tension produced is 40 N . The cross-sectional area of the steel wire is 1.0 mm^(2) and that of the aluminimum wire is 3.0 mm^(2) The minimum frequency of a tuning fork which can produce standing waves in the system with the joint as a node is 10P (in Hz ) the find P . Given density of aluminimum is 2.6 g//cm^(3) and that of steel is 7.8 g//cm^(3) .

The speed of a transverse wave going on a wire having a length 50 cm and maas 5.0 g is 80ms^(-1) The area of cross section of the wire is 1.0mm.^2 and its Young modulus is 16 xx 10^(11) N m^(-2). Find the extension of the wire over its natural lenth.

PREMIERS PUBLISHERS-PROPERTIES OF MATTER-OTHER IMPORTANT QUESTION & ANSWERS (MULTIPLE CHOICE QUESTIONS )
  1. Assertion: The size of a hydrogen balloon increases as it rises in ai...

    Text Solution

    |

  2. A man is sitting in a boat, which is floating on a pond. If the man dr...

    Text Solution

    |

  3. A thin liquid film formed between a U-shaped wire and a light slider s...

    Text Solution

    |

  4. An object is flowing through the liquid. The viscous damping force act...

    Text Solution

    |

  5. From the following figures, the correct observation is:

    Text Solution

    |

  6. If there were no gravity, which of the following will not be there for...

    Text Solution

    |

  7. Which one of the following pairs of physical quantities do not have th...

    Text Solution

    |

  8. Which one is not a dimensional number?

    Text Solution

    |

  9. Which one of the following liquids is represented by the curve given b...

    Text Solution

    |

  10. Select the correct statement of the follwing statements. The Reynold's...

    Text Solution

    |

  11. Which one of the following statements is a correct statement?

    Text Solution

    |

  12. The approximate depth of an ocean is 2700m. The compressibility of wat...

    Text Solution

    |

  13. Two rain drops falling through air have radii in the ratio 1:2, They w...

    Text Solution

    |

  14. Two capillaries of radii r(1)andr(2) and lengths l(1)andl(2) respectiv...

    Text Solution

    |

  15. Assertion: The parts of a machine are jammed in winter. Reason: Th...

    Text Solution

    |

  16. In the figure, the velocity v(3) will be:

    Text Solution

    |

  17. Blood is flowing at the rate of 200cm^(3)s^(-1) in a capillary of cros...

    Text Solution

    |

  18. The system shown in figure allowed to fall freely under gravity. The u...

    Text Solution

    |

  19. A lead shot of 1 mm diameter falls through a long colummn of glycerine...

    Text Solution

    |

  20. The work done against surface tension in blowing a soap bubble from a ...

    Text Solution

    |