Home
Class 11
CHEMISTRY
The antiseptic solution of iodopovidone ...

The antiseptic solution of iodopovidone for the use of external application contains `10%` w/v of iodopovidone. Calculate the amount of iodopovidone present in a typical dose of `1.5 mL.`

Text Solution

Verified by Experts

`10%w/v` means that 10 g of solute in 100 ml solution
`therefore ` Amount of iodopovidone in `1.5 mm = (10g)/( 100 ml) xx 1.5 ml = 0.15g`
Promotional Banner

Topper's Solved these Questions

  • SOLUTIONS

    FULL MARKS|Exercise ADDITIONAL QUESTIONS SOLVED (CHOOSE THE CORRECT ANSWER)|20 Videos

  • SOLUTIONS

    FULL MARKS|Exercise ADDITIONAL QUESTIONS SOLVED -MATCH THE FOLLOWING|5 Videos

  • SOLUTIONS

    FULL MARKS|Exercise TEXTUAL EVALUATION SOVED - LONG ANSWER QUESTIONS|10 Videos

  • SAMPLE PAPER-8

    FULL MARKS|Exercise Part-IV|10 Videos

  • SOLVED PAPER 03

    FULL MARKS|Exercise PART-IV|10 Videos

Similar Questions

Explore conceptually related problems

The depression in the freezing point of a benzene solution containing 0.784g of Acetic acid dissolved in 100ml of benzene is 0.35k. Calculate the van.t Hoff factor and the degree of association of the solute at this concentration (k_(f)" for benzene = 5.10 k.kg.mol"^(-1)," molar mass of acetic acid is 60.01").

If 5.6 of KOH is present in (a) 500 mL and (b) 1 litre of solution, calculate the molarity of each of these solutions.

A conducting loop in the form of a half circle of r=10cm is placed in a magnetic field as shown. The strength of the magnetic field is given by the relation B=5t^(2)+3t+5 where B is in Tesla and t- the time in seconds. The resistance of the loop is 3Omega . An ideal cell of e.m.f. E = 1.5V is connected to the loop. Calculate the induced e.m.f. and net current in the loop at t = 15 sec.

Consider a tank which initially holds V_(0) liter of brine that contains a lb of salt. Another brine solution, containing b lb of salt per liter is poured into the tank at the rate of eL//"min" . The problem is to find the amount of salt in the tank at any time t. Let Q denote the amount of salt in the tank at any time. The time rate of change of Q, (dQ)/(dt) , equals the rate at which salt enters the tank at the rate at which salt leaves the tank. Salt enters the tank at the rate of be lb/min. To determine the rate at which salt leaves the tank, we first calculate the volume of brine in the tank at any time t, which is the initial volume V_(0) plus the volume of brine added et minus the volume of brine removed ft. Thus, the volume of brine at any time is V_(0)+et-ft The concentration of salt in the tank at any time is Q//(V_(0)+et-ft) , from which it follows that salt leaves the tank at the rate of f(Q/(V_(0)+et-ft)) lb/min. Thus, (dQ)/(dt)=be-f(Q/(V_(0)+et-ft))Q=be A tank initially holds 100 L of a brine solution containing 20 lb of salt. At t=0, fresh water is poured into the tank at the rate of 5 L/min, while the well-stirred mixture leaves the tank at the same rate. Then the amount of salt in the tank after 20 min.

In the determination of internal resistance of a cell of e.in.f. 1.5 V with potentiometer, the balancing length is 75 cm in the open circuit and when a resistance of 10 Omega is used the balancing length is found to be 65 cm. Calculate the internal resistance of the cell.

Figure shows a 2.0 V potentiometer used for the determination of internal resistance of a 1.5 V cell. The balance point of the cell in open circuit is 76.3 cm. When a resistor of 9.5 Omega is used in the external circuit of the cell, the balance point shifts to 64.8 cm length of the potentiometer wire. Determine the internal resistance of the cell