Home
Class 8
PHYSICS
A spring made of copper is moved towards...

A spring made of copper is moved towards a stationary bar magnet. What are the changes observed in the spring when
(1) the to ends of the spring are connected.
(2) the two ends of the spring are not connected.

Text Solution

Verified by Experts

(i) Requirement for current to flow.
(ii) Difference between geographical axis and geographical meridian.
(iii) Change in the length of the spring.
(iv) Pole strength decreases when the area of cross-section of the bar magnet is reduced and the
Promotional Banner

Topper's Solved these Questions

  • ELECTROMAGNETISM

    PEARSON IIT JEE FOUNDATION|Exercise Concept Application (Level 3)|5 Videos

  • ELECTROMAGNETISM

    PEARSON IIT JEE FOUNDATION|Exercise TEST YOUR CONCEPS ( VERY SHORT ANSWER TYPE QUESTIONS)|32 Videos

  • ELECTROMAGNETISM

    PEARSON IIT JEE FOUNDATION|Exercise Concept Application (Level 1) MCQs|16 Videos

  • ELECTRICITY

    PEARSON IIT JEE FOUNDATION|Exercise CONCEPT APPLICATION (Level 3)|10 Videos

  • FORCE AND PRESSURE

    PEARSON IIT JEE FOUNDATION|Exercise COMPETITION CORNER |37 Videos

Similar Questions

Explore conceptually related problems

What will be the spring constant k of a. spring if length of the spring is made n times?

A block of mass m is moving with an initial velocity v_0 towards a stationary spring of stiffness k attached to the wall as shown in figure a. Find the maximum compression in the spring. b. Is the work done by the spring negative or positive?

A particle connected at the end of a spring executes SHM with a period T_(1) . While the corresponding period for another spring is T_(2) . When the two springs are connected inseries and particle is ocnnected at the one T. Find the relation between T, T_(1) and T_(2)

A light rod AB is fitted with a small sleeve of mass m which can slide smoothly over it. The sleeve is connected to the two ends of the rod using two springs of force constant 2k and k (see fig). The ends of the springs at A and B are fixed and the other ends (connected to sleeve) can move along with the sleeve. The natural length of spring connected to A is l_(0) . Now the rod is rotated with angular velocity w about an axis passing through end A that is perpendicular to the rod. Take (k)/(momega^(2)) = eta and express the change in length of each spring (in equilibrium position of the sleeve relative to the rod) in terms of l_(0) and eta .

A spring is made of steel and not of copper because

spring of force constant k clamped rigidly at onoe end and a mass m attached to its free end. A force F applied at the free end stretches the spring. Figure shows the same spring with both ends free and attached to a mass m at either end. Each end of the spring in figure is stretched by the same force F. (a) What is the maximum extension of the spring in the two cases ? (b) If the mass in figure and the two masses in figure are released free, what is the period of oscillation in each case?

A mass is suspended at the end of a spring and performs SHM with a time period 3 seconds, while the time period f same mass with other spring is 4 second. If that mass is connected with the combination of the two springs connected in series then time period of oscillator is

The time period of oscillations of a block attached to a spring is t_(1) . When the spring is replaced by another spring, the time period of the block is t_(2) . If both the springs are connected in series and the block is made to oscillate using the combination, then the time period of the block is