Home
Class 11
PHYSICS
The figure shows a schematic layout of h...

The figure shows a schematic layout of hydraulic jack. The load to be raised weighs 20,000N. The area of cross section of the two pistons are `A_(1)=50cm^(2)` and `A_(2)=10cm^(2)`. The force (F) is applied at theend of a ligh lever bar as shown in the figure. Lenghts a and b are 4cm and 36cm respectively. Find the force (F) required to raise the load slowly.

Promotional Banner

Similar Questions

Explore conceptually related problems

In a hydraulic jack as shown, mass of the car is m = 800 kg, A_(1) = 10 cm^(2) , A_(2) = 10 m^(2) . The minimum force F required to lift the car is

In a hydraulic jack as shown, mass of the car is m = 800 kg, A_(1) = 10 cm^(2) , A_(2) = 10 m^(2) . The minimum force F required to lift the car is

The area of cross sectioin of the two arms of a hydraulic press is 1cm^(2) and 20 cm^(2) respectively. A force of 10 N is applied on the water in the thinner arm. What force should be applid on the water in the thicker arms so that water may remain in equilibrium?

The area of cross sectioin of the two arms of a hydraulic press is 1cm^(2) and 20 cm^(2) respectively. A force of 10 N is applied on the water in the thinner arm. What force should be applid on the water in the thicker arms so that water may remain in equilibrium?

The area of cross section of the two arms of a hydraulilc press are 1 cm^2 and 10 cm^2 respectively figure. A force of 5N is applied on the water in the thinner arm. What force should be applied on the water in the thicker arm so that the water may remain in equilibrium? ,

The area of cross section of the two arms of a hydraulilc press are 1 cm^2 and 10 cm^2 respectively figure. A force of 5N is applied on the water in the thinner arm. What force should be applied on the water in the thicker arm so that the water may remain in equilibrium? ,

The area of cross section of the two arms of a hydraulilc press are 1 cm^2 and 10 cm^2 respectively figure. A force of 5N is applied on the water in the thinner arm. What force should be applied on the water in the thicker arm so that the water may remain in equilibrium? ,

The area of cross section of the two arms of a hydraulilc press are 1 cm^2 and 10 cm^2 respectively figure. A force of 5N is applied on the water in the thinner arm. What force should be applied on the water in the thicker arm so that the water may remain in equilibrium? ,

Two pistons (areas A_(1) and A_(2)) exerting forces F_(1) and F_(2) on a liquid exerts pressures P_(1) and P_(2) as shown in figure. The pistons are at the same horizontal level and do not move under the influence of force, then

Two pistons (areas A_(1) and A_(2)) exerting forces F_(1) and F_(2) on a liquid exerts pressures P_(1) and P_(2) as shown in figure. The pistons are at the same horizontal level and do not move under the influence of force, then