Length of a thin cylinder as measured by vernier callipers having least count `0.01cm` is `3.25cm` and its radius of cross-section is measured by a screw gauge having least count `0.01mm` as `2.75mm`. The percentage error in the measurement of volume of the cylinder will be

The length, breadth and thickness of a small uniform rectangular glass strip are 4.25cm , 6.25mm and 2.75mm . Its length is measured by vernier callipers of least count 0.01 cm and breadth and thickness were measured by screw gauge having least count 0.01mm . The percentage error in the measurement of volume of the strip is

Thickness of the paper mesaured by micrometer screw gauge of least count 0.01 mm is 1.03 mm, the percentage error in the measurement of thickness of paper is

Thickness of a pencil measured by using a screw gauge (least count.001 cm) comes out to be 0.802 cm .The percentage error in the measurement is

The length of a cylinder is measured with a metre rod having least count 0.1 cm. Its diameter is measured with vernier calliper having least count 0.01 cm. Given that length is 5.0 cm and radius is 2.00 cm. The percentage error in the calculated value of the volume will be

The length of a cylinder is measured with a meter rod having least count 0.1 cm. Its diameter is measured with vernier calipers having least count 0.01 cm. Given that length is 5.0 cm. and radius is 2.0 cm. The percentage error in the calculated value of the volume will be

Thickness of a cylinder measured using a screw gauge of least count 0.01cm is found to be equal to 0.80cm .The percentage error in measurement is

The dimensions of a rectangular block measured with a vernier callipers having least count of 0.1mm is 5mmxx10mmxx5mm . The maximum percentage error in measurement of volume of the blcok is

The length of a cyclinder is measured as 5 cm using a vernier calipers of least count 0.1 mm. The percentage error in the measured length is nearly

The diameter of a wire is measured by using a screw gauge having least count 0.01mm . If the diameter is found to be 0.20mm , then the error in the cross-section of the wire will be

If the zero error correction of a screw gauge with least of count 0.01 mm is +0.05 mm