A siphon tube is used to remove liquid from a container as shown in fig. In order to operate the siphon tube, it must initially be filled with the liquid.
(i). Determine the pseed of the liquid through the siphon.
(ii). Determine the pressure at the point C.

Figure shows a siphon , which is a device for removing liquid from a container . Tube ABC must initially be filled , but once this has been done , liquid will flow through the tube until the liquid surface in the container is level with the tube opening at A . The liquid has density 1000 kg//m^(3) and negligible viscosity . The distances shown are h_(1) = 25 cm d = 12 cm and h_(2) = 40 cm (a) With what speed does the liquid emerge from the tube at C ?

A siphon tube is discharging a liquid of specific gravity 0.9 from a reservoir as shown in the figure. (a) Find the velocity of the liquid through the siphon. (b) Find the pressure at the highest point B. (c ) Find the pressure at point C.

A siphon tube is discharging a liquid of specific gravity 0.9 from a reservoir as shown in the figure. (a) Find the velocity of the liquid through the siphon. (b) Find the pressure at the highest point B. (c ) Find the pressure at point C.

A siphon in use is demonstrated in the following figure. The density of the liquid flowing in siphon is 1.5 gm/cc The pressure difference between the points P and S will be.

A siphon is used to drain water (density =rho ) from a wide tank. The inlet and outlet mouth of the siphon are at the same horizontal level and the highest point of the siphon tube is at a height H from the mouth of the tube. Height of water in the tank above the tube mouth is h (see fig). Atmospheric pressure is P_(0) . (a) Will the water drain out in this siphon? if yes, at what speed (V)? (b) Find pressure at the top of the siphon tube (call in P) (c) Find pressure just inside the left mouth of the tube. (d) If left part of the tube is slightly cut short, without disturbing anything else, what effect it will have on V and P? (e) If the right end of the tube is lowered by adding more lenght of tube, it was observed that flow stops when lenght of right limb of the tube becomes H_(0) . Find H_(0) .