Home
Class 11
PHYSICS
(i) A non uniform cube of side length a ...

(i) A non uniform cube of side length a is kept inside a container as shown in the figure. The average density of the material of the cube is 2 `rho` where `rho` is the density of water. Water is gradually fille din the container. It is observed that the cube begins to topple, about its edge into the plane of the figure passing through pointA, when the height of the water in the container becomes `(a)/(2)`. Find the distance of the centre of mass of the cube from the face AB of the cube. Assume that water seeps under the cube.

(ii) A rectangular concrete block (specific gravity =2.5) is used as a retatining wall in a reservoir of water. The height and width of the block are x and y respectively the height of water in the reservoir is `z=(3)/(4)x`. the concrete block cannot slide on the horizontal base but can rotate about an axis perpendicular to the plane of the figure and passing through point A

(a) Calculate the minimum value of the ratio `(y)/(x)` for which the block will not begin to overturn about A.
(b) Redo the above problem for the case when there is a seepage and a thin film of water is present under the block. Assume that a seal at A prevents the water from flowing out underneath the block.

Promotional Banner

Similar Questions

Explore conceptually related problems

A 10 cm cube floats in water with a height of 4 cm remaining above the surface. The density of the material from which the cube is made is, ..........

A container filled with a liquid of density 4p as shown in the figure. The velocity efflux through orifice is ( rho is density of water and g = 10 ms^(-2) )

A force F is applied on the top of a cube as shown in the figure. The coefficient of friction between the cube and the ground is mu . If F is gradually increased, find the value of mu for which the cube will topple before sliding.

A force F is applied on the top of a cube as shown in the figure. The coefficient of friction between the cube and the ground is mu . If F is gradually increased, find the value of mu for which the cube will topple before sliding.

Consider a cube of uniform charge density rho . The ratio of electrostatic potential at the centre of the cube to that at one of the corners of the cube is

A cube of each side a is kept in an electric field given by E=cx (as shown in the figure) where c is a positive dimensional constant. Find out (i) The electric flux through the cube and (ii) The net charge inside the cube.

A container shown in figure contains a liquid to depth H, and of density rho The gauge pressure at point P is :

A cube is pplaced on an inclined plane of inclinbation theta as shown in figure. Cofficent of friction br=etween the cube and the plane is mu . As the angle theta is gradually increased, the cube slides before toppling if