A hydraulic automobile lift is designed ...

A hydraulic automobile lift is designed to lift cars with a maximum mass of 3000 kg. The area of cross section of the piston carrying the load is `425 cm^2`.What maximum pressure would the smaller piston have to eat?

Text Solution

Verified by Experts

`6.92 times 10^5 Pa`

Topper's Solved these Questions

MECHANICAL PROPERTIES OF FLUIDS
NCERT BANGLISH|Exercise EXERCISE|43 Videos
LAW OF MOTION
NCERT BANGLISH|Exercise EXERCISE (ADDITIONAL EXERCISE)|17 Videos
MECHANICAL PROPERTIES OF SOLIDS
NCERT BANGLISH|Exercise Exercises|16 Videos

Similar Questions

Explore conceptually related problems

Two cylinders of different area of cross section are connected to each other with a pipe. The area of cross section of wider cylinder is 800 cm^2 ?. If a mass of 16kg is placed on the massless airtight frictionless piston in the wider cylinder, find the difference in the level of water in the two cylinders

The radii of two pistons in a hydraulic press are 5cm and 15cm respectively. A force F_1 exerted in the small piston can lift a car of mass 1350 kg placed on the larger piston. What is the value of F_1 ? What is the pressure necessary to accomplish the task?

What will be the increase in length of a wire of length 10 m undergoing a strain of 0.001%? If the cross sectional area of the wire 2mm^2 and the load applied at its end is 1 kg, then calculate the stress developed in dyn.cm^-2 .

A frictionless piston-cylinder based enclosure contains some amount of gas at a pressure of 400kPa. Then heat is transferred to the gas at constant pressure in a quasi-static process. The piston moves up slowly through a height of 10cm. If the piston has a cross-sectional area of 0.3m^(2) , the work done by the gas in this process is

A steel cable with a radius of 1.5 cm supports a chair-lift at a ski area. IF the maximum stress does not exceed 10^8 N.m^-2 , what is the maximum load that the cable can support?

NCERT BANGLISH-MECHANICAL PROPERTIES OF FLUIDS -EXERCISE

Torricelli's barometer used mercury. Pascal duplicated it using French...
Text Solution
|
A vertically-off shore structure is built to withstand a maximum stres...
Text Solution
|
A hydraulic automobile lift is designed to lift cars with a maximum ma...
Text Solution
|
A U-tube contains water and methylated spirit separated by mercury. Th...
Text Solution
|
In the previous problem, If 15.0 cm of water and spirit each are furth...
Text Solution
|
Can Bernoulli's equations be used to describe the flow of water throug...
Text Solution
|
Does it matter if one uses gauge instead of absolute pressures in appl...
Text Solution
|
Glycerine flows steadly through a horizontal tube of length 1.5 m and ...
Text Solution
|
In a test experiment on a model aeroplane in a wind tunnel, the flow s...
Text Solution
|
Figures 10.23(a) and (b) refer to the steady flow of a (non-viscous) l...
Text Solution
|
The cylindrical tube of a spray pump has a cross section of 8.0 cm^2 o...
Text Solution
|
A U-shaped wire is dipped in a soap solution, and removed. The thin so...
Text Solution
|
Figure 10.24(a) shows a thin liquid film supporting a small weight =4....
Text Solution
|
What is the pressure inside the drop of mercury of radius 3.00mm at ro...
Text Solution
|
What is the excess pressure inside a bubble of soap solution of radius...
Text Solution
|
A tank with a square base of area 1.0 m^2 is divided by a vertical pos...
Text Solution
|
A manometer reads the pressure of a gas in an exclosure as shown in fi...
Text Solution
|
Two vessels have the same area but different shapes. The first shapes ...
Text Solution
|
During blood transfusion the needle is inserted in a vein where the ga...
Text Solution
|
In deriving Bernoulli's equation, we equated the work done on the flui...
Text Solution
|