Home
Class 12
PHYSICS
A uniform metal pole of height 30.0 m an...

A uniform metal pole of height 30.0 m and mass 100 kg is initially standing upright but then falls over to one side without its lower end sliding or losing contact with the ground. What is the linear speed of the pole's upper end just before impact?

Text Solution

Verified by Experts

29.7 m/s
Promotional Banner

Topper's Solved these Questions

  • RIGID BODY DYNAMICS - I

    RESNICK AND HALLIDAY|Exercise PRACTICE QUESTIONS (SINGLE CORRECT CHOICE TYPE)|43 Videos

  • RIGID BODY DYNAMICS - I

    RESNICK AND HALLIDAY|Exercise PRACTICE QUESTIONS (MORE THAN ONE CORRECT CHOICE TYPE)|7 Videos

  • RIGID BODY DYNAMICS - I

    RESNICK AND HALLIDAY|Exercise CHECKPOINT|18 Videos

  • RELATIVITY

    RESNICK AND HALLIDAY|Exercise PRACTICE QUESTIONS (Integer Type)|5 Videos

  • RIGID BODY DYNAMICS-II

    RESNICK AND HALLIDAY|Exercise PRACTICE QUESTIONS (Integer Type)|2 Videos

Similar Questions

Explore conceptually related problems

A uniform rod of mas m and length l is kept vertical with the lower end clamed. It is slightly pushed to let it fall down under gravity. Find its angular speed when the rod is passing through its lowest positon. Neglect any friction at the clamp. What will be the linear speed of the free end at this instant?

A uniform ladder of length 10.0 m and mas 16.0 kg is resting against a vertical smooth wall making an angle of 37^@ with it. An electrian weighing 60.0 kg climbs up the ladder. If the stays on the ladder at a point 8.00 m from the lower end, what will be normal force and the force of friction on the ladder by the ground? What should be the minimum coefficient of friction for the electician to work safely?

A uniform chain of mass m and length l is lying on a horizontal table with one-third of its length hanging over the edge of the table. What is the speed of the chain, when it just loses contact with the table?

A uniform flag pole of length L and mass M in pivoted on the ground with a frictionless hinge. The flag pole makes an angle theta with the horizontal. The moment of inertia of the flag pole about one end is (1//3) ML^(2) . If starts falling from the position shown in figure, the linear acceleration of the free end of the flag pole-labeled P - would be. .

A uniform rod of length 1m and mass 0.5 kg rotates at angular speed of 6 rad//sec about one of its ends. What is the KE (in joule) of the rod ?

A uniform thin rod of mass m and length L is standing vertically along the y-axis on a smooth horizontal surface, with its lower end at the origin (0,0). A slight disturbane at t = 0 causes the lower end t slip on the smooth surface along the positive x-axis, and the rod starts falling. (i) What is the path followed by the centr of mass of the rod during its fall? (ii) Find the equaiton to the trajectory of a point on the rod shape of the path of this point?

a. A rail road flat car of mass M can roll without friction along a straight horizontal track . Initially, a man of mass m is standing on the car which is moving to the right with speed v_(0) . What is the change in velocity of the car if the man runs to the left so that his speed relative to the car is v_(rel) just before he jumps off at the left end? b. If there are n men each of mass m on the car, should they all run and jump off together or should they run and jump one by one in order to give a greater velocity to the car?

A uniform metal rod of length L and mass M is rotating about an axis passing throuth one of the ends perpendicular to the rod with angular speed omega . If the temperature increases by t^@C then the change in its angular velocity is proportional to which of the following ? (Coefficient of linear expansion of rod =alpha )

RESNICK AND HALLIDAY-RIGID BODY DYNAMICS - I-PROBLEMS
  1. A pulley, with a rotational inertia of 1.0xx10^(-3)kg*m^(2) about its ...

    Text Solution

    |

  2. (a) If R = 15 cm, M = 350 g, and m = 50 g in Fig. 10-19, find the spee...

    Text Solution

    |

  3. A uniform metal pole of height 30.0 m and mass 100 kg is initially sta...

    Text Solution

    |

  4. A thin rod of length 0.75 m and mass 0.42 kg is suspended freely from ...

    Text Solution

    |

  5. A metre stick is held vertically with one end on the floor and is then...

    Text Solution

    |

  6. A uniform cylinder of radius 12 cm and mass 25 kg is mounted so as to ...

    Text Solution

    |

  7. A tall, cylindrical chimney falls over when its base is ruptured. Trea...

    Text Solution

    |

  8. A uniform spherical shell of mass M = 4.5 kg and radius R = 8.5 cm can...

    Text Solution

    |

  9. Figure shows a rigid assembly of a thin hoop (of mass m and radius R =...

    Text Solution

    |

  10. In unit vector notation, find the net torque about the origin on a par...

    Text Solution

    |

  11. In unit vector notation, find the torque about a point at coordinates ...

    Text Solution

    |

  12. In unit vector notation, what is the torque about the origin on a part...

    Text Solution

    |

  13. A particle moves through an xyz coordinate system while a force acts o...

    Text Solution

    |

  14. Force vecF=(2.0N)hati-(3.0N)hatk acts on a pebble with position vector...

    Text Solution

    |

  15. A force vecF=(6.00hati-4.00hatj)N acts on a particle with position vec...

    Text Solution

    |

  16. At the instant of Figure, a 2.0 kg particle P has a position vector ve...

    Text Solution

    |

  17. A particle of mass m is shot from ground level at initial speed u and ...

    Text Solution

    |

  18. A 3.0 kg particle-like object moves in a plane with velocity component...

    Text Solution

    |

  19. Two particles each of mass m and speed v, travel in opposite direction...

    Text Solution

    |

  20. At the instant the displacement of a 1.50 kg object relative to the or...

    Text Solution

    |