What force should be applied on the wedge so that block over it does not move? (All surfaces are smooth)

Find the minimum acceleration of the wedge, so that the block is under free fall (assume all surfaces tivate v are smooth).

Find the minimum acceleration of the wedge, so that the block is under free fall (assume all surfaces tivate v are smooth).

A block of mass 2 kg rests on an inclined plane which makes an angle of 30^(@) with the horizontal. The coefficient of friction between the block and the surface is sqrt(3//2) . (i) What force should be applied on the block so that it moves down without any acceleration ? (ii) What force should be applied on the block so that it moves up without any acceleration ? (iii) Calculate the ratio of the powers in the above two cases if the block moves with uniform speed in both the cases.

A block of mass m is placed on an inclined plane. With what acceleration A towards right should the system move on a horizontal surface so that m does not slide on the surface of inclined plane? Also calculate the force supplied by wedge on the block. Assume all surfaces are smooth.

A block of mass m is placed on an inclined plane. With what acceleration A towards right should the system move on a horizontal surface so that m does not slide on the surface of inclined plane? Also calculate the force supplied by wedge on the block. Assume all surfaces are smooth.

A block of mass m is placed on an inclined plane. With what acceleration A towards right should the system move on a horizontal surface so that m does not slide on the surface of inclined plane? Also calculate the force supplied by wedge on the block. Assume all surfaces are smooth.

A wedge of mass M makes an angle theta with the horizontal. The wedge is placed on horizontal frictionless surface. A small block of mass m is placed on the inclined surface of wedge. What horizontal force F must be applied to the wedge so that the force of friction between the block and wedge is zero ?

When a block is placed on a wedge as shown in figure, the block starts sliding down and the wedge also start sliding on ground. All surfaces are rough. The centre of mass of ( wedge + block ) system will move.

A wedge of mass m is placed on a horizontal smooth table. A block of mass m is placed at the mid point of the smooth inclined surface having length L along its line of greatest slope. Inclination of the inclined surface is theta= 45^(@) . The block is released and simultaneously a constant horizontal force F is applied on the wedge as shown. (a) What is value of F if the block does not slide on the wedge? (b) In how much time the block will come out of the incline surface if applied force is 1.5 times that found in part (a)