Home
Class 10
MATHS
In a classroom, 4 friends are seated at...

In a classroom, 4 friends are seated at the points A. B. C and D as shown in Fig. 7.8. Champa and Chameli walk into the class and after observing for a few minutes Champa asks Chameli, Don't you think ABCD is a square? Chameli disagrees. Using distance formula, find which of them is correct.

Text Solution

AI Generated Solution

To determine whether the points A, B, C, and D form a square, we will use the distance formula. The distance formula between two points \((x_1, y_1)\) and \((x_2, y_2)\) is given by: \[ D = \sqrt{(x_2 - x_1)^2 + (y_2 - y_1)^2} \] ### Step 1: Identify the coordinates of points A, B, C, and D Let's assume the coordinates of the points are as follows: ...
Promotional Banner

Topper's Solved these Questions

  • COORDINATE GEOMETRY

    NCERT ENGLISH|Exercise EXERCISE 7.3|5 Videos
  • COORDINATE GEOMETRY

    NCERT ENGLISH|Exercise SOLVED EXAMPLES|15 Videos
  • CONSTRUCTIONS

    NCERT ENGLISH|Exercise EXERCISE 11.2|7 Videos
  • INTRODUCTION TO TRIGONOMETRY

    NCERT ENGLISH|Exercise EXERCISE 8.3|7 Videos

Similar Questions

Explore conceptually related problems

(a) what is the rate at which energy being delivered to a light bulb higher : just after it is turned on , the glow of the filament is increasing , or after it has been on for a few seconds and the glow is steady ? (b) IF a piece of wire is used to connect points b and c in Fig. 7.9, does the brightness of bulb R_(1) increase , decrease or stay constant ? What happens to the brightness of bulb R_(2) ? (I_(1) = I_(2) = I) (c) Compare the brightness of four identical light bulbs in Fig. 7.10 . What happens if the bulb A fails so that it cannot conduct ? What if C fails ? What if D fails? (d) If electric power is transmitted over long distances, the resistance of the wires becomes significant. Why ? Which mode of transmission would result in less energy losss: high current and low voltage or low current and high voltage ? Discuss. (e) In Fig. 7.11 , describe wha happens to the light bulb after the switch is closed . Assume the capacitor has a large capacitance and is initially uncharged. (f) Astuident claims that a second light bulb in series is less bright than the first , because the first bulb uses up some of the current . How would you respond to this statement ? (g) If you were to design an electeric heater using nichrome wire as the heating element , what parameters of the wire would you vary to meet a specific power output , sch as 1000 W ?

A situation is shown in which two objects A and B start their motion from same point in same direction. The graph of their velocities against time is drawn. u_A and u_B are the initial velocities of A and B respectively. T is the time at which their velocities become equal after start of motion. You cannot use the data of one question while solving another question of the same set. So all the questions are independent of each other. 7. After 10 s of the start of motion of both objects A and B, find the value of velocity of A if u_A = 6 ms^-1 , u_B = 12 ms^-1 and at T velocity of A is 8 ms^-1 and T = 4s