An electric kettle for use on a 230 V su...

An electric kettle for use on a 230 V supply is rated at 3000 W. For safe working, the cable connected to it should be able to carry at least:

10A

15A

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

ELECTRICITY
ZEN PUBLICATION|Exercise ZEN ADDITIONAL QUESTIONS SECTION (LONG ANSWER QUESTIONS)|30 Videos
LIGHT - REFLECTION AND REFRACTION
ZEN PUBLICATION|Exercise ZEN ADDITIONAL QUESTIONS SECTION (LONG ANSWER [LA] QUESTIONS)|30 Videos

Similar Questions

Explore conceptually related problems

Several electric bulbs designed to he used on a 220 V electric supply line, are rated 10 W. How many lamps can be connected in parallel with each other across the two wires of 220V line of the maximum allowable current is 5A ?

An electric heater supplies heat to a system at a rate of 100W. If system performs work at a rate of 75 joules per second. At what rate is the internal energy increasing?

An electric heater rated 220 V and 550 W is connected to AC mains. The current drawns by it is

An electric bulb rated 220V, 100W is connected to a source of 220 (0.8)V then actual power will be

a] What is the function of fuse in an electric circuit? b] What would be the rating of the fuse for an electric kettle which is operated at 220V and consumes 500W power? c] How is the SI unit of electric energy related to its commerical unit?

An electric toaster uses nichrome for its heating element. When a negllgibly small current pases through it, its resistance at room temperature (27.0^(@)C) is found to be 75.3 Omega. When the toaster is connected to a 230 V supply, the current settles, after a few seconds, to a steady value of 2.68A. What is the steady temperature of the nichrome element ? The temperature coefficient of resistance of nichrome averaged over the temperature range involved is 1.70 xx 10 ^(-4)"" ^(@)C ^(-1).

A family uses 8 kW of power. Direct solar energy is incident on the horizontal surface at an average rate of 200W per sq. m. If 20% of this energy can be converted into useful electrical energy, how large an area is needed to supply 8 kW?

ZEN PUBLICATION-ELECTRICITY-ZEN ADDITIONAL QUESTIONS SECTION (MULTIPLE CHOICE QUESTIONS)

The resistance of a conductor is 27Omega. If it is cut into three equa...
Text Solution
|
A piece of metallic wire of resistance R is cut into 3 equal parts. Th...
Text Solution
|
An electric kettle for use on a 230 V supply is rated at 3000 W. For s...
Text Solution
|
At a given time, a house is supplied with 100 A at 220 V. How many 75 ...
Text Solution
|
If the potential difference between the ends of a fixed resistor is ha...
Text Solution
|
The heat produced in a wire of resistance 'X' when a current 'Y' flows...
Text Solution
|
If the current flowing through a fixed resistor is halved, the heat pr...
Text Solution
|
A cell, a resistor, a key and ammeter are arranged as shown in the cir...
Text Solution
|
Electrical resistivity of a given metallic wire depends upon
Text Solution
|
What is the maximum resistance which can be made using five resistors ...
Text Solution
|
What is the minimum resistance which can be made using five resistors ...
Text Solution
|
Which of the following represents voltage?
Text Solution
|
Unit of electric power may also be expressed as
Text Solution
|
Which of the following statements does not represent Ohm's law?
Text Solution
|
Two resistances of 100 Ω and zero ohm are connected in parallel. Th...
Text Solution
|
Three resistors 2 Ω, 3Ω and 4Ω are connected so that the equivalent re...
Text Solution
|
When a current 'l' flows through a resistance 'R' for time 't' the ele...
Text Solution
|
When a fuse is rated 8 A, it means
Text Solution
|
The work done in moving a unit positive charge across two points in an...
Text Solution
|
The potential at a point is 20 V. The work done to bring a charge of 0...
Text Solution
|