How friction force is provided on vehicl...

How friction force is provided on vehicle taking turn on level circular path ?

Text Solution

Verified by Experts

Friction force between road any tyre.

Topper's Solved these Questions

LAW OF MOTION
KUMAR PRAKASHAN|Exercise SECTION-D(NCERT EXEMPLAR SOLUTIONS)|42 Videos
LAW OF MOTION
KUMAR PRAKASHAN|Exercise SECTION -E(MULTIPLE CHOICE QUESTIONS) (MCQS)|69 Videos
LAW OF MOTION
KUMAR PRAKASHAN|Exercise SECTION -B (NUMERICAL FROM DARPAN BASED ON TEXTBOOK)|8 Videos
GRAVITATION
KUMAR PRAKASHAN|Exercise QUESTIONS PAPER Section - D|1 Videos
MACHANICAL PROPERTIES OF SOLIDS
KUMAR PRAKASHAN|Exercise QUESTION PAPER|11 Videos

Similar Questions

Explore conceptually related problems

How centripetal is provided while taking turn on level circular track ?

Do motion of vehicle on level circular path depend on mass of vehicle ?

A car is moving along a banked road laid out as a circle of radius r . (a) What should be the banking angle theta so that the car travelling at speed v needs no frictional force from tyres to negotiate the turn ? (b) The coefficient of friction between tyres and road are mu_(s) = 0.9 and mu_(k) = 0.8 . At what maximum speed can a car enter the curve without sliding toward the top edge of the banked turn ?

Which component of force provide centripetal force to vehicle moving with optimum speed ?

STATEMENT-1: It is easier to pull a heavy object than to push it on a level ground and STATEMENT-2: The magnitude fo frictional force depends on the nature of the two surfaces in contact.

A bob of mass m is attached at one end of a string of length l other end of the string is fixed at point O . Bob is rotating in a circular path of radius l in horizontal plane about O with constant speed v , as shown in the figure. The average force exterted by string on the bob during its :- (A) half revolution will be (mv^(2))/(pil) (B) half revolution will be (2mv^(2))/(pil) (C) one fourth revolution will be (sqrt2mv^(2))/(pil) (D) one revolution will be zero Select correct alternative :-

A small ball of mass m and charge q is attached to the bottom end of a piece of negligible mass thread of length l, whose top end is fixed. The system formed by the thread and ball is in vertical plane and is in uniform horizontal magnetic field B, which is perpendicular to the plane of figure and points into the paper The ball is started with a velocity v_(0) from lower most point of circle in a direction perpendicular both to the magnetic induction and to direction of thread. The ball moves along a circular path such that thread remains tight during the whole motion. Neglect any loss of enery. By what factor is the force acting on the thread (tension in thread) at point A is greater than at point C, when speed of the ball is the above stated one?

KUMAR PRAKASHAN-LAW OF MOTION-SECTION-C(OBJECTIVE QUESTIONS) (VSQS)

A bus of mass 1000 kg is standing stationary on bus station what is i...
Text Solution
|
When direction of object moving on circular path is changed what will ...
Text Solution
|
How friction force is provided on vehicle taking turn on level circula...
Text Solution
|
On which place on the surface of the earth, centripetal force is maxim...
Text Solution
|
On which place on the surface of the earth, centripetal force is maxim...
Text Solution
|
Why curved road are provided with slope ?
Text Solution
|
An object is subjected to num ber of external forces. Can this object ...
Text Solution
|
Why more force is needed to bring heavier mass in motion with definite...
Text Solution
|
An object of 18 gram mass is lying on slope of 60^(@). If 36 dyne forc...
Text Solution
|
A 10 kg wooden block is lying stationary on rough horizontal surface. ...
Text Solution
|
What is the acceleration of train moving with speed of 50 ms^(-1) on c...
Text Solution
|
A stone is tied at end of string and whirled in horizontal plane with ...
Text Solution
|
Because of which property of the object it tries to oppose the change ...
Text Solution
|
W hen body is said to be in equilibrium condition ?
Text Solution
|
Momentum is product of velocity and magnitude of velocity”. True or Fa...
Text Solution
|
“If a body do not have kinetic energy, then it do not have momentum al...
Text Solution
|
Give dimensional formula of impulse of force.
Text Solution
|
Time rate of change of momentum gives which physical quantity
Text Solution
|
Which physical quantity represents the differentiation of linear momen...
Text Solution
|
How we can find impulse of force when very small force act on body for...
Text Solution
|