Home
Class 12
PHYSICS
The rms value of a.c. signal in halfwave...

The rms value of a.c. signal in halfwave rectifier is ……

A

equal to value of D.C.

B

more than the value of D.C.

C

less than the value of D.C.

D

zero

Text Solution

Verified by Experts

The correct Answer is:
B
Promotional Banner

Topper's Solved these Questions

  • SEMICONDUCTOR ELECTRONICS : MATERIALS, DEVICES AND SIMPLE CIRCUITS

    KUMAR PRAKASHAN|Exercise Section-D : Multiple Choice Questions (MCQs) (MCQs From .DARPAN. Based On Textbook)|116 Videos

  • SAMPLE QUESTION PAPER

    KUMAR PRAKASHAN|Exercise PART-B SECTION-C|5 Videos

  • WAVE OPTICS

    KUMAR PRAKASHAN|Exercise SECTION-D (MULTIPLCE CHOICE QUESTIONS (MCQS)) (MCQS FROM DARPAN BASED ON TEXTBOOK)|239 Videos

Similar Questions

Explore conceptually related problems

(a) The peak voltage of an ac supply is 300 V. What is the rms voltage? (b) The rms value of current in an ac circuit is 10 A. What is the peak current?

What are A.C. signals ?

A sinusoidal voltage of amplitude 25 volts and frequency 50 Hz is applied to a half wave rectifier using PN diode. No filter is used and the load resistor is 1000 Omega . The forward resistance R_(f) ideal diode is 10 Omega . Calculate. (i) Peak, average and rms values of load current (ii) d.c power output (ii) a.c power input (iv) % Rectifier efficiency (v) Ripple factor.

(a) The peak voltage of an ac supply is 300V. What is the rms voltage ? The rms value of current in an circuit is 10V. What is the peak current ?

The peak voltage in the output of a half wave diode rectifier fed with a sinusoidal signal without filter is 10V. The d.c. component of the output voltage is ……..

The ratio of r.m.s. value of an A.C. voltage and its mean value over half cycle is ....

An A.C. supply of 350 V, 60 Hz is applied to a full wave rectifier. If internal resistance of each diode is 200Omega and load resistance R_(1)=5k Omega , then the maximum value of output current is …….

Calculate the peak value of current if the crest factor is 10 and the rms value is 2A.

In series L-C-R circuit, resistance, inductance and capacitance are connected in series. The value of potential difference across three are 70 V, 90 V and 65 V respectively. The value of potential difference of A.C. source is …...

A 100 Omega resistor is connected to a 200V, 50 Hz ac supply. (a) What is the rms value of current in the circuit ? (b) What is the net power consumed over a fully cycle ?

KUMAR PRAKASHAN-SEMICONDUCTOR ELECTRONICS : MATERIALS, DEVICES AND SIMPLE CIRCUITS -Section-D : Multiple Choice Questions (MCQs) (MCQs asked in Competitive Exams)
  1. Obtain the resonant frequency and Q-factor of a series LCR circuit wit...

    Text Solution

    |

  2. A circular loop enters a uniform magnetic field as shown in the figure...

    Text Solution

    |

  3. The rms value of a.c. signal in halfwave rectifier is ……

    Text Solution

    |

  4. The valency of the impurity atom added to make germanium crystal into ...

    Text Solution

    |

  5. To a germanium sample, traces of galium are added as an impurity. The ...

    Text Solution

    |

  6. When the semiconductor is heated ……..

    Text Solution

    |

  7. Which logic gate is represented by the following logic gates?

    Text Solution

    |

  8. A Ge specimen is doped with Al. The concentration of acceptor atoms is...

    Text Solution

    |

  9. Which of the following logic gate is an universal gate?

    Text Solution

    |

  10. Write the truth table for circuit given in figure below consisting of ...

    Text Solution

    |

  11. A light emitting diode (LED) has a voltage drop of 2 volt across it an...

    Text Solution

    |

  12. In half wave rectification, what is the output frequency if the input ...

    Text Solution

    |

  13. The forbidden gap in the energy bonds of silicons is ……

    Text Solution

    |

  14. Which among the following is applicable to tapetum? (A) Protective la...

    Text Solution

    |

  15. When the inputs of a two input logic gate are 0 and 0, the output is 1...

    Text Solution

    |

  16. Which logic gate is represented by the following logic gates?

    Text Solution

    |

  17. The direction of the electric field in p-n junction diode is …….

    Text Solution

    |

  18. When the electromagnetic radiation of maximum wavelength of 2480 nm is...

    Text Solution

    |

  19. To create AND gate require ……NAND gate.

    Text Solution

    |

  20. What kind of p-n junction diode does not require any kind of bias?

    Text Solution

    |