In half wave rectification, what is the ...

In half wave rectification, what is the output frequency if the input frequency is 50 Hz.

25 Hz

50 Hz

70.7 Hz

100 Hz

Text Solution

Verified by Experts

The correct Answer is:

50 Hz

In half wave rectification, the negative wave part of cutoff but as for requency, they will be same as seen from the figures. Therefore, this also will be frequency of 50 Hz (50 cycle/s) .

Topper's Solved these Questions

SEMICONDUCTOR ELECTRONICS : MATERIALS, DEVICES AND SIMPLE CIRCUITS
KUMAR PRAKASHAN|Exercise Section-D : Multiple Choice Questions (MCQs) (MCQs From .DARPAN. Based On Textbook)|116 Videos
SAMPLE QUESTION PAPER
KUMAR PRAKASHAN|Exercise PART-B SECTION-C|5 Videos
WAVE OPTICS
KUMAR PRAKASHAN|Exercise SECTION-D (MULTIPLCE CHOICE QUESTIONS (MCQS)) (MCQS FROM DARPAN BASED ON TEXTBOOK)|239 Videos

Similar Questions

Explore conceptually related problems

Two sitar strings A and B playing the note 'Dha' are slightly out of tune and produce beats of frequency 5 Hz, The tension of the string B is slightly increased and the beat frequency is found to decrease to 3 Hz. What is the original frequency of B if the frequency of A is 427 Hz ?

Two sitar strings A and B playing the note 'Dha' are slightly out of tune and produce beats of frequency 5 Hz. The tension of the string B is slightly increased and the beat frequency is found to decrease to 3 Hz. What is the original frequency of B if the frequency of A is 427 Hz ?

If the input frequency is 50 Hz in fullwave rectification, what is the output frequency?

In a full wave rectifier if input freq, is 50 Hz then output nipple frequency will be :-

Find the time period of the wave whose frequency is 500Hz?

A pure inductor of 25.0 mH is connected to a source of 220 V . Find the inductive reactance and rms current in the circuit if the frequency of the source is 50 Hz.

A pure inductor of 25.0 mH is connected to a source of 220 V. Find the inductive reactance and rms current in the circuit if the frequency of the source is 50 Hz.

In a full wave rectifier circuit operating from 50 Hz mains frequency, the fundamental frequency in the ripple would be ………

KUMAR PRAKASHAN-SEMICONDUCTOR ELECTRONICS : MATERIALS, DEVICES AND SIMPLE CIRCUITS -Section-D : Multiple Choice Questions (MCQs) (MCQs asked in Competitive Exams)

Write the truth table for circuit given in figure below consisting of ...
Text Solution
|
A light emitting diode (LED) has a voltage drop of 2 volt across it an...
Text Solution
|
In half wave rectification, what is the output frequency if the input ...
Text Solution
|
The forbidden gap in the energy bonds of silicons is ……
Text Solution
|
Which among the following is applicable to tapetum? (A) Protective la...
Text Solution
|
When the inputs of a two input logic gate are 0 and 0, the output is 1...
Text Solution
|
Which logic gate is represented by the following logic gates?
Text Solution
|
The direction of the electric field in p-n junction diode is …….
Text Solution
|
When the electromagnetic radiation of maximum wavelength of 2480 nm is...
Text Solution
|
To create AND gate require ……NAND gate.
Text Solution
|
What kind of p-n junction diode does not require any kind of bias?
Text Solution
|
The doping of minute quantity of antimony to a silicon crystal makes i...
Text Solution
|
How much is potential barrier in Si diode at room temperature?
Text Solution
|
When will the conductivity of a Ge semiconductor decrease?
Text Solution
|
Write the symbol, truth table, function and Boolean equation for OR g...
Text Solution
|
n-type semiconductor is obtained on doping intrinsic germanium by …….
Text Solution
|
A hole in a p-type semiconductor is ……. in a covalent bond.
Text Solution
|
An AND gate is followed by a NOT gate in series with two inputs A and ...
Text Solution
|
In the shown figure the focal length of equivalent system in the form ...
Text Solution
|
Seperated p-type semiconductor is electrically ………
Text Solution
|