A
B
C
D
Text Solution
Verified by Experts
The correct Answer is:
Topper's Solved these Questions
UNITS AND MEASUREMENTS
AAKASH SERIES|Exercise ADDITIONAL PRACTICE EXERCISE (LEVEL - II) LECTURE SHEET (ADVANCED)|15 VideosUNITS AND MEASUREMENT
AAKASH SERIES|Exercise Practice Exercise|45 VideosVECTORS
AAKASH SERIES|Exercise Additional Practice Exercise (Practice Sheet (Advanced)) (Integer Type Questions)|6 Videos
AAKASH SERIES-UNITS AND MEASUREMENTS -ADDITIONAL PRACTICE EXERCISE (PRACTICE SHEET (ADVANCED))
- Two clocks are being tested against a standard clock located in a nati...
Text Solution
|
- The pitch of a screw gauge is 1mm and there are 50 divisions on its ca...
Text Solution
|
- The pitch of a screw gauge is 1mm and there are 100 divisions on its c...
Text Solution
|
- If L, C, R represent inducatance, capaitance and resistance respective...
Text Solution
|
- Which of the following uses vernier scale
Text Solution
|
- Select the correct statement(s) for a given vernier callipers, when th...
Text Solution
|
- Least count of a vernier callipers is 0.01 cm. When the two jaws are i...
Text Solution
|
- Screw gauge can be used to determine.
Text Solution
|
- The main scale of vernier callipers has 10 equal divisions in 1 cm and...
Text Solution
|
- The ratio of magnitudes of unit for viscosity in SI to that in CGS is ...
Text Solution
|
- The pressure on a square plate is measured by measuring the force on t...
Text Solution
|
- In the formula P=(nRT)/(V-b)e^((-a)/(RTV)), Find the dimensions of len...
Text Solution
|
- In column - I names of measuring instruments are mentioned and column ...
Text Solution
|
- An object is held firmly in between the two studs of a screw gauge. By...
Text Solution
|