In carnot engine efficiency is 40% at ho...

In carnot engine efficiency is 40% at hot reservoir temperature T. For efficiency to be 50%, what will be the temperature of hot reservoir ?

`T/5`

`(2T)/(5)`

`(6T)/(5)`

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

THERMODYNAMICS
AAKASH SERIES|Exercise ADDITIONAL PRACTICE EXERCISE (LEVEL - II (LECTURE SHEET (ADVANCED)) STRAIGHT OBJECTIVE TYPE QUESTIONS)|10 Videos
THERMODYNAMICS
AAKASH SERIES|Exercise ADDITIONAL PRACTICE EXERCISE (LEVEL - II (LECTURE SHEET (ADVANCED)) MORE THAN ONE CORRECT ANSWER TYPE QUESTIONS)|3 Videos
THERMODYNAMICS
AAKASH SERIES|Exercise PRACTICE SHEET (EXERCISE - II (LEVEL - II (INTEGER TYPE QUESTIONS)))|2 Videos
THERMAL PROPERTIES OF MATTER
AAKASH SERIES|Exercise ADDITIONAL PRACTICE EXERCISE (LEVEL - II) PRACTICE SHEET (ADVANCED) Integer/Subjective Type Questions|2 Videos
THERMOMETRY
AAKASH SERIES|Exercise Numerical Exercise (LEVEL- 1)|11 Videos

Similar Questions

Explore conceptually related problems

Efficiency of a Carnot engine is 50% when temperature of outlet is 500 K. In order to increase efficiency up to 60% keeping temperature of intake the same what is temperature of outlet

Consider a reversible engine of efficiency 1/6 when the temperature of the sink is reduced by 62 ^@C , its efficiency gets doubled . The temperature of the source and sink respectively are

Efficiency of a heat engine whose sink is at temperature of 300 K is 40% . To increase the efficiency to 60 % keeping the sink temperature same, the source temperature must be increased by

The efficiency of a carnot heat engine depend on

A carnot engine absorbs heat from a reservoir maintained at temperature 1000K. The engine rejects heat to a reservoir whose temperature is T. If the magnitude of a absorbed heat is 400J and work performed is 300J, then the value of T is

AAKASH SERIES-THERMODYNAMICS-ADDITIONAL PRACTICE EXERCISE (LEVEL - I (MAIN) STRAIGHT OBJECTIVE TYPE QUESTIONS)

Entropy of a thermodynamic system does not change when this system is ...
Text Solution
|
In a P-V diagram for an ideal gas (where P is along the y-axis and V i...
Text Solution
|
Internal energy of n1 moles of hydrogen at temperature T is equal to ...
Text Solution
|
In carnot engine efficiency is 40% at hot reservoir temperature T. For...
Text Solution
|
A container having 1 mole of a gas at a temperature 27^@C has a movab...
Text Solution
|
An ideal gas is found to obey pV^(3/2) = constant during an adiabatic ...
Text Solution
|
By opening the door of a refrigerator inside a closed room:
Text Solution
|
During the melting of a slab of ice at 273 K at atmospheric pressure:
Text Solution
|
Which of the following parameters does not characterise the thermodyna...
Text Solution
|
An ideal gas has molar specific heat 5R/2 at constant pressure. If 300...
Text Solution
|
Consider the following statement. The internal energy of an ideal mono...
Text Solution
|
At atmospheric pressure, 2 g of water having a volume of 2.00cm become...
Text Solution
|
What is the most likely value for Cr (molar heat capacity at constant...
Text Solution
|
Ideal gas undergoes an adiabatic change in its state form (P1 , V1 , T...
Text Solution
|
Then two moles of oxygen is heated from 0^@C to 10^@C at constant vol...
Text Solution
|
If heat Q is added reversibly to a system at temperature T and heat Q....
Text Solution
|
Which of the graphs shown below represents the variation of beta = -1...
Text Solution
|
100 g of water is heated from 30^@C to 50^@C. Ignoring the slight expa...
Text Solution
|
A carnot engine operating between temperatures T1 and T2 has efficien...
Text Solution
|
A thermally insulated vessel contains an ideal gas of molecular mass M...
Text Solution
|