Home
Class 12
PHYSICS
To produce 10^3 Joules of heat in 10 sec...

To produce `10^3` Joules of heat in 10 seconds, how much voltage should be applied to 100 ohm resistance?

Promotional Banner

Topper's Solved these Questions

  • Electric Charges and Electrostatic Force

    PUNJAB BOARD PREVIOUS YEAR PAPERS|Exercise Exercise|39 Videos
  • Electric Field

    PUNJAB BOARD PREVIOUS YEAR PAPERS|Exercise Exercise|35 Videos

Similar Questions

Explore conceptually related problems

Two forces are applied on a block of mass m = 2 kg . How much force should be applied and in which direction to produce an acceleration of 1m//s^2 . The surface is smooth. towards right?

A galvanometer of 50 ohm resistance has 25 divisions. A current of 4xx10^(-4) ampere gives a deflection of one division. To convert this galvanometer into a voltmeter having a range of 25 volts, it should be connected with a resistance of

In a series resonant circuit, the a.c. voltage across resistance R, inductance L and capacitance C are 5 V. 10 V and 10 V respectively. The a.c. voltage respetively. The a.c. voltage applied to the circuit will be

Write an expression for the amount of heat produced in a wire of resistance R and carrying a current I for time. An electric heater of resistance 10 ohm draws 15 A from the service mains for 2 hours. Calculate the heat developed in the heater?

Write an expression for the amount of heat produced in a wire of resistance R and carrying a current I for time. An electric heater of resistance 10 ohm draws 15 A from the service mains for 2 hours. Calculate the power of the heater.

Four resistors of 15ohm, 12ohm, 4ohm and 10ohm given in cyclic order to form a wheat stone bridge. What resistance (in ohm) should be connected in parallel across the 10ohm resistor to balance the wheat stone bridge .

A capacitor having capacity of 2 muF is charged to 200 V and then the plates of the capacitor are connected to a resistance wire. The heat produced in joule will be

A transistor connected in cdmmon emitter configuration has input resistance Ri = 2k Omega (kilo ohm) and load resistance 6k Omega (kilo ohm). If current gain beta = 60 and input signal 10 mV (millivolt) is applied, calculate resistance gain

PUNJAB BOARD PREVIOUS YEAR PAPERS-Electric Current, Resistance and E.M.F. -Exercise
  1. What is the colour coding of strips on the carbon resistor of resitor ...

    Text Solution

    |

  2. A letter .A. consists of a uniform wire of resisrtance .A. one ohm per...

    Text Solution

    |

  3. To produce 10^3 Joules of heat in 10 seconds, how much voltage should ...

    Text Solution

    |

  4. A current of 5 ampere flows in a 10 ohm resistor. Calculate rate of he...

    Text Solution

    |

  5. A heater is rated as 220 volts, 880 watts. What is the current drawn b...

    Text Solution

    |

  6. A carbon resistor has three colours yellow, blue and red respectively....

    Text Solution

    |

  7. A carbon resistor has three colours red, yellow and blue respectively....

    Text Solution

    |

  8. Two resistances when connected in series give a total resistance of 18...

    Text Solution

    |

  9. Two resistances are inthe ratio of 1:4.If these are connected in paral...

    Text Solution

    |

  10. Two resistances when connected in series give a resistance of 9Q and w...

    Text Solution

    |

  11. How will you represent aresistance of 3700 Omega +- 10% by colour codi...

    Text Solution

    |

  12. Calculate the resistivity of the material of wire 1.0 m (meter) long 0...

    Text Solution

    |

  13. A wire of length15m (meter) and uniform area of cross section 6.0 xx 1...

    Text Solution

    |

  14. A wire of length 2.0 m, diameter 1.0 mm has 50 xx 10^-3 Omega (ohm) re...

    Text Solution

    |

  15. A parallel combination of three resistors takes a current of 5A from a...

    Text Solution

    |

  16. The parallel combination of three resistors takes a current of 7.5A fr...

    Text Solution

    |

  17. A series combination of three resistors takes a current of 2A from a 2...

    Text Solution

    |

  18. A wire has a resistance of 10.5Omega at 21^@C and 16.4Omega at 147^@C....

    Text Solution

    |

  19. A resistance of a tungsten filament at 150^@C is 133Omega.What will be...

    Text Solution

    |

  20. A silver wire has a resistance of 2.1Omega at 27.5^@C and a resistance...

    Text Solution

    |