Home
Class 12
PHYSICS
At what value should the variable resist...

At what value should the variable resistor be set such that the bridge is balanced? If the source voltage is 30 V find the value of the output voltage across XY, when the bridge is balanced.

Promotional Banner

Topper's Solved these Questions

  • Current Electricity

    CHETANA PUBLICATION|Exercise Exercise|92 Videos
  • AC CIRCUITS

    CHETANA PUBLICATION|Exercise Exercise|122 Videos
  • Dual Nature of Radiation and Matter

    CHETANA PUBLICATION|Exercise EXERCISE|89 Videos

Similar Questions

Explore conceptually related problems

Two resistances 2 ohm and 3 ohm are connected across the two gaps of the metre bridge as shown in the figure .Calculate the current through the cell when the bridge is balanced and the specific resistance of the material of the metre bridge wire. Given the resistance of the bridge wire is 1.49 ohm and its diameter is 0.12 cm.

When the voltage applied across a bulb is 220 v the current passing through the bulb is 0.1 A . Find the power of the bulb.

When an a.c. current passes through a 14 Omega resistor, the power loss is 224 W. Find the r.m.s. values of current and voltage. Also find the maximum values of current and voltage. Find the steady value of current which when passed through this resistor will produce the same power loss as the a.c. current.

When a resistor of 5 Omega resistance is connected across a cell,its terminal potential difference is balanced by 150 cm of the wire and when a resistor of 10 Omega resistance is connected across cell, the terminal p.d. is balanced by 175 cm of same potentiometer wire. Find the balancing length when the cell is in open circuit and the internal resistance of acell.

A 2.0 V potentiometer is used to determine the internal resistance of 1.5 V cell. The balance point of the cell in the circuit is 75 cm . When a resistor of 10Omega is connected across cel, the balance point sifts to 60 cm . The internal resistance of the cell is

Figure shows a potentiometer circuit for comparison of two resistances.The balance point with a standard resistor R=10.0 Omega is found to be 58.3 cm,while that with the unknown resistance X is 68.5 cm. Determine the value of X. What might you do if you failed to find a balance point with the given cell of emf E ?

A peak value of alternating voltage is 494.97 V. Find reading on voltmeter used to measure it?

A coil having an inductance of 1/pi henry is connected in series with a resistance of 300Ω. if 20 volt from a 200 cycle source are impressed across the combination, the value of the phase angle between the voltage and the current is :

A Wheatstone's bridge shown in figure , is to be balanced . The value of chi must be , 4 Omega 8 Omega 16 Omega 32 Omega

CHETANA PUBLICATION-Current Electricity-Exercise
  1. At what value should the variable resistor be set such that the bridge...

    Text Solution

    |

  2. (1)In the following circuit, calculate the value of the current (I).

    Text Solution

    |

  3. In an electric circuit, the currents 2A, 1.5A and 3A flow towards the ...

    Text Solution

    |

  4. A resistance of 2Omega is connected in parallel to a galvanometer of r...

    Text Solution

    |

  5. A galvanometer has a resistance of 16Omega. It shows full scale deflec...

    Text Solution

    |

  6. A moving coil galvanometer has a resistance of 25Omega and goes a full...

    Text Solution

    |

  7. The combined resistance of a galvanometer of resistance 500Omega and i...

    Text Solution

    |

  8. A potentiometer wire has a resistance per unit length of 0.1 Omega//m....

    Text Solution

    |

  9. Resistance of potentiometer wire is 0.1Omega//cm. A cell of emf 1.5V i...

    Text Solution

    |

  10. In a balanced meterbridge, the segment of wire opposite to 20Omega is ...

    Text Solution

    |

  11. A uniform wire is cut into two pieces such that on piece is twice as l...

    Text Solution

    |

  12. Two coils are connected in series in one gap of the meterbridge and nu...

    Text Solution

    |

  13. A skeleton tube is made of 12 wires each of resistance ROmega is conne...

    Text Solution

    |

  14. A skeleton tube is made of 12 wires each of resistance ROmega is conne...

    Text Solution

    |

  15. A skeleton tube is made of 12 wires each of resistance ROmega is conne...

    Text Solution

    |

  16. A galvanometer has resistance of 25 Omega capacity to carry a maximum ...

    Text Solution

    |

  17. At what point the null point be obtained in meterbridge experiment whe...

    Text Solution

    |

  18. The potentiometer wire has length 10m and resistance 10Omega, if the c...

    Text Solution

    |

  19. The potentiometer wire has length 10m and resistance 10Omega, if the c...

    Text Solution

    |

  20. When a resister of 10Omega is connected across a cell, its terminal po...

    Text Solution

    |

  21. Two cells having unknown emfs E1 and E2 (E1 > E2) are connected in pot...

    Text Solution

    |