Home
Class 10
CHEMISTRY
Low current should be used for longer ti...

Low current should be used for longer time.

Text Solution

AI Generated Solution

Promotional Banner

Topper's Solved these Questions

  • ELECTROLYSIS

    ICSE|Exercise WORK SHEET -3 (Complete the following table with respect to extraction of aluminium : )|1 Videos

  • ELECTROLYSIS

    ICSE|Exercise WORK SHEET -3 (Answer the following questions : )|4 Videos

  • ELECTROLYSIS

    ICSE|Exercise WORK SHEET -3 (Fill in the blanks )|10 Videos

  • CHEMISTRY-2015

    ICSE|Exercise SECTION-II (40 Marks) Attempt any four questions from this Section.|49 Videos

  • METALLURGY

    ICSE|Exercise UNIT TEST PAPER 6 - Metallurgy (Select the correct answer from the list A,B,C & given in each statement.) |5 Videos

Similar Questions

Explore conceptually related problems

......... current should be used for electroplating.

......... current should be used for electrolysis.

Give reasons why? Direct current should be used during electroplating.

Ravish exercised for 3/6 an hour, while Rohit exercised for 3/4 of an hour Who exercised for a longer time ?

Rafiq exercised for 3/6 of an hour, while Rohit exercised for 3/4 of an hour. Who exercised for a longer time?

In the meter bridge shown , the resistance X has a negative temperature coefficient of resistance Negiecting the variaiton in other resistors, when current is passed for some time , in the circuit balance point should shift towards .

(A) Plot V-I characteristics for an illuminated photo diode under reverse bias for three different illumination intensities I_1 gt I_2 gt I_3 . (B) In a zener regulated power supply, a zener diode with V_2 = 6 V is used for regulation. the load current should be 4.0 mA and zener current is five times the load current for unregulated input of 10 V. Find the series resistor R_3 used in the power supply.

The average value of current for the current shown for time period 0 to (T)/(2) is

Heart sound which is longer is

In the circuit shown in the figure initialy the switch in position 1 for a long time, then suddenly at t=0 the switch is shifted to position 2. It is required that a constant current should flow in the circuit, the value of resistance R in the circuit