A vernier caliper with a least count of of `0.01 cm` was used to measure diameter of cylinder as `4 cm` and a scale `(0-15cm)` with the least count of `1 mm` was used to measue a length of `5cm`. The `%` error in the measurement of volume of the cylinder is

Length of a thin cylinder as measured by vernier callipers having least count 0.01cm is 3.25cm and its radius of cross-section is measured by a screw gauge having least count 0.01mm as 2.75mm . The percentage error in the measurement of volume of the cylinder will be

Thickness of a cylinder measured using a screw gauge of least count 0.01cm is found to be equal to 0.80cm .The percentage error in measurement is

A student measured the diameter of a wire using a micrometer with least count 0.001 cm and listed the measurement. The correct measurement is

A student measured the diameter of a wire using a screw gauge with least count 0.001 cm and listed the measurements. The correct measurement is

A student measured the diameter of a wire using a screw gauge with least count 0.001cm and listed the measurement. The correct measurement is

To calculate the volume of cylinder, a student is given a metre scale of least count 1 mm to measure its length and vernier callipers of least count 0.1 mm to measure its diameter. If its length and radius are 10 cm and 2 cm respectively then the percentage error in the calculated value of the volume of the cylinder will be

A student measured the diameter of a solid cylinder using a micrometer screw gauge of least count 0.001 cm and took the following readings. Which is the correct measurement?

Thickness of a pencil measured by using a screw gauge (least count.001 cm) comes out to be 0.802 cm .The percentage error in the measurement is