Home
Class 12
PHYSICS
The circuit diagram (see fig.) shows a '...

The circuit diagram (see fig.) shows a 'logic combination' with the states outputs `X,Y` and `Z` given for input `P,Q,R` and `S` all at state `1` (i.e., high). When inputs `P` and `R` change to state `0` i.e., low) with inputs `Q` and `S` still at `1`, the condition of output `X,Y` and `Z` chages to

A

`X = 0 , Y = 0 , Z = 0 `

B

` X = 1, Y = 1 , Z = 1 `

C

` X = 0 , Y = 1 , Z = 0 `

D

`X = 1, Y = 0 , Z = 0 `

Text Solution

Verified by Experts

The correct Answer is:
C
Promotional Banner

Similar Questions

Explore conceptually related problems

In the given circuit P and Q from the inputs. The output Y is

For the given combination of gates, if the logic states of inputs A,B,C, are as follows A=B=C=0 and A=B=1, C=0 then the logic states of output D are

(i) Identify the logic gates marked P and Q in the given logic circuit Fig. (ii) Write down the output at X for the inputs A=0, B=0 and A=1, B=1 .

(i) Identify the logic gates marked P and Q in the given logic circuit. (ii) Write down the output at X for the inputs A = 0 , B = 0 and A = 1 , B = 1.

The lines x=y=z meets the plane x+y+z=1 at the point P and the sphere x^2+y^2+z^2=1 at the point R and S, then

Figure below shows the circuit of an electronic device : (i) Which electronic device : a rectifier, an amplifier or an oscillator does the above circuit represent? (ii) State where the input voltage is applied and 1 where the output voltage is available. (iii) Compare the output voltage of this circuit with its input voltage.

(a) Draw the circuit diagram of a full wave rectifier using p-n junction diole. Explain its working and show the output, input waveforms. (b) Show the output waveforms (Y) for the following inputs A and B of (i) OR gate (ii) NAND gate :

A plane meets the coordinate axes in A ,B ,C such that the centroid of triangle A B C is the point (p ,q ,r)dot Show that the equation of the plane is x/p+y/q+z/r=3.

The amplifiers X, Y and Z are connected in series. If the voltage gains of X, Y and Z are 10, 20 and 30 , respectively and the input signal is 1mV peak value, then what is the output signal voltage (peak value) (i) if dc supply voltage is 10V ? (ii) if dc supply voltage is 5V?