Home
Class 11
PHYSICS
In a common base mode of a transition ,...

In a common base mode of a transition , the collector current is `5.488 mA` for an emitter currect of `5.60 mA` . The value of the base current amplification factor `(beta)` will be

A

49

B

50

C

51

D

48

Text Solution

Verified by Experts

The correct Answer is:
A
`beta=(I_(C))/(I_(B))=(5.488xx10^(-3))/((5.6-5.488)xx10^(-3))=49`
Promotional Banner

Topper's Solved these Questions

  • SEMICONDUCTORS

    ALLEN |Exercise Part-3(Exercise-3)|27 Videos

  • PHYSICAL WORLD, UNITS AND DIMENSIONS & ERRORS IN MEASUREMENT

    ALLEN |Exercise EXERCISE-IV|7 Videos

  • WAVES AND OSCILLATIONS

    ALLEN |Exercise Part-1(Exercise-05)[B]|42 Videos

Similar Questions

Explore conceptually related problems

The current gain of a common base transistor circuit is 0.96. On changing the emitter current by 10.0 mA, the change in the base current will be .....

In an NPN transistor the collector current is 10 mA . If 90% of electrons reach collector, the emitter current (i_(E)) and base current (i_(B)) are given by

Transistor with beta = 75 is connected to common-base configuration. What will be the maxima collector current for an emitter current of 5 mA ?

The current of transistor in common emitter mode is 49. The change in collector current and emitter current corresponding to the change in the base current by 5.0 muA m will be :-

For a common emitter amplifier, current gain = 50. If the emitter current is 6.6 mA, calculate the collector and base current. Also current gain. When emitter is working as common base amplifier,

In the CB mode of a transistor, when the collector voltage is changed by 0.5 volt. The collector current changes by 0.05 mA . The output resistance will be

Calculate the collector and emitter current for which I_(b) = 20 mA, beta = 100

For a common base configuration of PNP transistor (l_(C))/(l_(E))=0.98 , then maximum current gain in common emitter configuration will be

An n-p-n transistor in a common emitter mode is used as a simple voltage amplifier with a collector connected to load resistance R_(L) and to the base through a resistance R_(B) . The collector-emmiter voltage V_(CE) = 4V , the base-emitter voltage V_(BE) = 0.6 V , current through collector is 4 mA and the current amplification factor beta = 100 Calculate the value of R_(L) and R_(B) .

When a 12V battery is connected across an unknown resistor, there is a current of 2.5 mA in the circuit. Find the value of the resistance of the resistor.

ALLEN -SEMICONDUCTORS-Part-3(Exercise-4)
  1. In a common emitter amplifier circuit using a n-p-n transistor, the ph...

    Text Solution

    |

  2. In a full wave rectifier circuit operating from 50 Hz mains frequency...

    Text Solution

    |

  3. In a common base mode of a transition , the collector current is 5.48...

    Text Solution

    |

  4. A solid which is transparent to visible light an whose conductivity in...

    Text Solution

    |

  5. Ratio of number density of holes is (7)/(5) and ratio of their current...

    Text Solution

    |

  6. The circuit has two oppsitely ideal diodes in parallel. What is the cu...

    Text Solution

    |

  7. In the following, which one of the diodes is reverse biased ?

    Text Solution

    |

  8. If the lattice constant of this semiconductor is decreased, then which...

    Text Solution

    |

  9. Carbon, silicon and germanium have four valence electrons each. At roo...

    Text Solution

    |

  10. If a p-n junction diode, a square input signal of 10 V is applied as s...

    Text Solution

    |

  11. A working transitor with its three legs marked P, Q and R is tested us...

    Text Solution

    |

  12. In the circuit below, A and B represents two inputs and C represents t...

    Text Solution

    |

  13. a p -n juction (D) shown in the figure can act an a rectifier An alter...

    Text Solution

    |

  14. The logic circuit shown below has the input waveform 'A' and 'B' as sh...

    Text Solution

    |

  15. The combination of gates shown below yields :-

    Text Solution

    |

  16. The question has statement - 1 and statement - 2 Of the four choices ...

    Text Solution

    |

  17. If the output of the OR gate is connected to both inputs of the NAND g...

    Text Solution

    |

  18. Which of the following four alternatives is not correct, We need modul...

    Text Solution

    |

  19. Truth table for system of four NAND gates as shown in figure is : .

    Text Solution

    |

  20. A diode detector is used to detect an amplitude modulated wave of 60% ...

    Text Solution

    |