Home
Class 11
PHYSICS
An experiment is preformed to determine ...

An experiment is preformed to determine the `I-V` characteristics of a Zener diode, which has a protective resistance of `R = 100 Omega`, and maximum power of dissipation rating of 1 W. The minimum voltage range of the DC source in the circuit is :-

A

`0-24 V`

B

`0-12 V`

C

`0-8 V`

D

`0.5 V`

Text Solution

Verified by Experts

The correct Answer is:
A
Promotional Banner

Topper's Solved these Questions

  • SEMICONDUCTORS

    ALLEN |Exercise Part-3(Exercise-3)|27 Videos

  • PHYSICAL WORLD, UNITS AND DIMENSIONS & ERRORS IN MEASUREMENT

    ALLEN |Exercise EXERCISE-IV|7 Videos

  • WAVES AND OSCILLATIONS

    ALLEN |Exercise Part-1(Exercise-05)[B]|42 Videos

Similar Questions

Explore conceptually related problems

A Zener diode is specified having a breakdown voltage of 9.1 V with a maximum power dissipation of 364 mW. What is the maximum current that the diode can handle.

An inductor of reactance 1 Omega and a resistor of 2 Omega are connected in series to the terminals of a 6 V (rms) a.c. source. The power dissipated in the circuit is

The emf of a battery is 2V and its internal resistance is 0.5Omega the maximum power which it can deliver to any external circuit will be

(a) Six lead-acid type of secondary cells each of emf 2.0 V and internal resistacne 0.015Omega are joined in series to provide a supply to a resistance of 8.5 Omega. What are the current drawn from the suply and its terminal voltage ? (b) A secondary cell after long use has an emf of 1.9 V and a large internal resistance of 380 Omega. What maximum current can be drawn from the cell? Could the cell drive tghe starting motor of a car ?

An electric iron consumes energy at a rate of 840 W, when heating is at the maximum rate and 360 W, when heating is atthe minimum. The voltage is 220V. What are the current and the resistance in each case?

For a cell terminal potential difference is 2.2 V when circuit is open and reduces to 1.8V when cell is connected to a resistance of R= 5Omega then determine internal resistance of cell is:-

The potentiometer wire of length 100cm has a resistance of 10Omega . It is connected in series with a resistance of 5Omega and an accumulaot or emf 3V having negligible resistance. A source 1.2V is balanced against a length 'L' of the potentionmeter wire. find the value of L.

Suppose the loop is stationary but the current feeding the electromagnet that produces the magnetic field is gradually reduced so that the field decreases from its initial value of 0.3 T at the rate of 0.02 T s^(-1) . If the cut is joined and the loop has a resistance of 1.6 Omega , how much power is dissipated by the loop as heat ? What is the source of this power ?

A student performs an experiment to determine how the range of a ball depends on the velocity with which it is projected. The "range" is the distance between the points where the ball lends and from where it was projected, assuming it lands at the same height from which it was projected. It each trial, the student uses the same baseball, and launches it at the same angle. Table shows the experimental results. |{:("Trail","Launch speed" (m//s),"Range"(m)),(1,10,8),(2,20,31.8),(3,30,70.7),(4,40,122.5):}| Based on this data, the student then hypothesizes that the range, R, depends on the initial speed v_(0) according to the following equation : R=Cv_(0)^(n) , where C is a constant and n is another constant. The student speculates that the constant C depends on :- (i) The angle at which the ball was launched (ii) The ball's mass (iii) The ball's diameter If we neglect air resistance, then C actually depends on :-

ALLEN -SEMICONDUCTORS-Part-3(Exercise-4)
  1. Truth table for system of four NAND gates as shown in figure is : .

    Text Solution

    |

  2. A diode detector is used to detect an amplitude modulated wave of 60% ...

    Text Solution

    |

  3. The I- V characteristic of on LED is

    Text Solution

    |

  4. The forward biased diode connection is

    Text Solution

    |

  5. A single of 5 kHz frequency is amplitude modulated on a carrier wave o...

    Text Solution

    |

  6. In an unbiased p-n junction electrons diffuse from n-region to p-regio...

    Text Solution

    |

  7. A 2V battery is connected across AB as shown in the figure. The value ...

    Text Solution

    |

  8. The value of the resistor, R(S), needed in the dc voltage regulator ci...

    Text Solution

    |

  9. Choose the correct statement.

    Text Solution

    |

  10. For common emitter configuration, if alpha and beta have their usual m...

    Text Solution

    |

  11. if a,b,c,dare inputs to a gate and x is its output , then as per the f...

    Text Solution

    |

  12. The temperature dependence of resistances of Cu and undoped Si in the ...

    Text Solution

    |

  13. An audio signal consists of two distinct sound. One a human speech sig...

    Text Solution

    |

  14. An unknown transistor needs to be identified as npn and pnp type. A mu...

    Text Solution

    |

  15. An experiment is preformed to determine the I-V characteristics of a Z...

    Text Solution

    |

  16. The truth table given below belongs for which gates {:(A,B,Y),(0,0,0...

    Text Solution

    |

  17. A modulated signal Cm(t) has the form Cm(t) = 30 sin 300pi t + 20 (cos...

    Text Solution

    |

  18. The ratio (R) of output resistance r0 and the input resistance r, in m...

    Text Solution

    |

  19. To get an output 1, the input ABC should be :-

    Text Solution

    |

  20. A realistic graph depiciting the variation of thhe reciprocal of input...

    Text Solution

    |