Home
Class 12
BIOLOGY
Autotomy of arms is shown by...

Autotomy of arms is shown by

A

Star Fish

B

Brittle Star

C

Sea Lily

D

All the above.

Text Solution

Verified by Experts

The correct Answer is:
D
Promotional Banner

Topper's Solved these Questions

  • ECHINODERMATA

    DINESH PUBLICATION ENGLISH|Exercise REVISION QUESTIONS|65 Videos

  • DIVERSITY IN ANGIOSPERM MORPHOLOGY

    DINESH PUBLICATION ENGLISH|Exercise Check your Grasp|10 Videos

  • ENVIRONMENTAL ISSUES

    DINESH PUBLICATION ENGLISH|Exercise Model test paper-5|100 Videos

Similar Questions

Explore conceptually related problems

Autotomy occurs in

A u tube contains water and methylated spirit separated by mercury. The mercury columns in the two arms are at the same levels with 10 cm of water in one arm and 12.5 cm of spirit on the other arm as shown. If 15 cm of water and spirit each are further poured into the respective arms of the tube. Difference in the level of mercury in the two arms is (Take, relative density of mercury = 13.6, relative density of spirit=0.8)

Autotomy is recorded in

In which type of chromosome, one arms is very long and one arm is very short

A U-tube open from both ends, contain two arms, arm-1 and arm-2 each of having equal cross-section and height of each arm is 1m. Water of density rho_(w) and an unknown liquid of density rho is fliied as shown A tuning fork of frequency 300 Hz is vibrated on arm-1, then air column vibrated is fundamental tone. If the same tuning fork is vibrated on arm-2, then air column vibrates in 1st overtone V_("sound") = 300 m//sec , g = 10//sec^(2) , density of water rho_(w) = 10^(3)kg//m^(2) , atmospheric pressure = 10^(2) Pa) Nelect the effect of surface tension and end correction : Npw we use a tuning fork of frequency 302 Hz, instead of 300 Hz, with how much velocity should we move the tuning fork, so that resonance is created with the air column in any arm ?

1. In the figure given above, what do A and B represent? 2. What are the distances x and y called? 3. For levers, it can be shown that "Load"/"Effort"= "Length of effort arm"/" Effort Length of load arm" Using this information, state the value of the ratio, load/effort, for the figure shown above.

The figure shows a rectangular conducting frame MNOP of resistance R placed partly in a perpendicular magnetic field vecB and moved with velocity vecV as shown in the figure. Obtain the expressions for the (a) force acting on the arm 'ON' and its direction, and (b) power required to move the frame to get a steady emf induced between the arms MN and PO.

Draw a diagram of a lever which is always used as a force multiplier. How is the effort arm related to the load arm in such a lever ?

An open -ended U-tube of uniform cross-sectional area contains water (density 1.0 g//cm^(23) ) standing initially 20 cm from the bottom in each arm. An immiscible liquid of density 4.0 g//cm^(2) is added to one arm until a layer 5 cm high forms, as shown in the figure above. What is the ratio h_(2)//h_(1) of the heights of the liquid in the two arms ?