Home
Class 6
PHYSICS
Complete the drawing shown in Fig 12.14 ...

Complete the drawing shown in Fig 12.14 to indicate where the free ends of the two wires should be joined to make the bulb glow.

Text Solution

Verified by Experts


Earlier, the connection is not complete as one of the end of the cell is not connected to the switch and hence the bulb. Thus, there will be no flow of current in the circuit.
To complete the circuit, one of the end of the cell must be connected to the switch and then to the bulb. After this, bulb will start glowing as shown in the figure
Promotional Banner

Topper's Solved these Questions

Similar Questions

Explore conceptually related problems

Look at the circuit shown here What should be done to make the bulb glow?

The potentiometer wire AB shown in figure is 40 cm long. Where the free end of the galvanometer should be connected on AB so that the galvanometer may show zero deflection?

The potentiometer wire AB shown in figure is 40 cm long. Where should the free end of the galvanometer be connected on AB so that the galvanometer may show zero deflection?

Various parts on the outer surface of an electric cell are labelled as I, II, III, and IV respectively in figure (a). In figure (b), an incomplete circuit is shown. M and N are the free ends of this circuit. To make the bulb glow, free ends M and N of the circuit should be respectively connected to

Various parts on the outer surface of an electric cells are labelled as I, II, III and IV respectively in figure (a). In figure (b), an incomplete circuit is shown. M and N are the free ends of this circuit. To make the bulb glow, free ends M and N of the circuit should be respectively connected to

The schematic diagram of an open circuit is shown in the given figure. Opa ends Which of the following objects is inserted tightly in the gap to make the bulb glow?

Boojho has a cell and a single piece of connecting wire. Without cutting the wire in two, will he be able to make the bulb glow? Explain with the help of a circuit diagram.