The diode used in figure requires minimu...

The diode used in figure requires minimum current of ImA to be above the knee voltage characteristics. The maximum value of R so that the voltage is above knee point is (Knee voltage of diode is 0.7V)

`5 k Omega `

`5.7 k Omega `

`4.3 k Omega `

`3.5 Omega `

Text Solution

Verified by Experts

The correct Answer is:

Topper's Solved these Questions

SEMICONDUCTOR DEVICES
AAKASH SERIES|Exercise PRACTICE EXERCISE (TRANSISTORS )|8 Videos
SEMICONDUCTOR DEVICES
AAKASH SERIES|Exercise PRACTICE EXERCISE (LOGIC GATES )|15 Videos
SEMICONDUCTOR DEVICES
AAKASH SERIES|Exercise EXERCISE -II (LOGIC GATES)|12 Videos
RAY OPTICS
AAKASH SERIES|Exercise PROBLEMS ( LEVEL-II)|60 Videos
UNITS AND MEASUREMENT
AAKASH SERIES|Exercise PRACTICE EXERCISE|45 Videos

Similar Questions

Explore conceptually related problems

The junction diode in the following circuit requires a minimum current of 1 mA to be above the knee point (0.7 V) of its I-V characterstic curve. The voltage across the diode is independent of current above the knee point. If V_(B)=5 V , then the maximum value of R so that the voltage is above the knee point, will be

The 6 V Zener diode shown in the figure has negligible resistance and a knee current of 5 mA. The minimum value of R (in Omega ) so that the voltage across it does not fall below 6 V is

What is the value of output voltage V_(0) in the circuit shown in the figure ?

If current in diode is five times that in R_(1). Breakdown voltage of diode is 6 volt. Find R= ?

If voltage across zener diode is 6V then find out value of maximum resistance in this condition.

In an RC series circuit(in fig), the rms voltage of source is 200V and its frequency is 50 Hz, if R=100 Omega and C=(100)/(pi) muF , find (a) inpedance of the circuit. (b) power factor angle, (c ) power factor, (d) current, (e) maximum current (f) voltage across R, (g) voltage across C, (h) maximum voltage across R, (i) maximum voltage across C, (j) ltPgt , (k) ltP_(R )gt . (l) ltP_(C )gt (m) i(t) , V_(R )(t),and V_(C)(t) .

In the voltage current (V-l) characteristics of junction diode (figure) the point A and B corresponds to

An ideal diode is connected in a circuit with resistance R=5Omega and V=10 volt as shown in figure maximum and minimum value of output voltage. When no load applied is (assume diode to be ideal)

The diode used in the circuit shown in the figure has a constant voltage drop of 0.5 V at all currents and a maximum power rating fo 100 milliwatts. What should be the value of the resistor R , connected in series with the diode for obtaining maximum current?

AAKASH SERIES-SEMICONDUCTOR DEVICES-PRACTICE EXERCISE (ENERGY BANDS AND CLASSIFICATION OF SOLIDS )

The diagram correctly represent the direction of flow of charge carrie...
Text Solution
|
The barrier potential in an ideal P-n junction diode is 0.3 volts. The...
Text Solution
|
The diode used in figure requires minimum current of ImA to be above t...
Text Solution
|
Calculate the value of R, if the maximum value of forward current of t...
Text Solution
|
The potential barrier existing across an unbiased p-n junction is 0.2 ...
Text Solution
|
In a p-n junction, a potential barrier of 250 meV exists across the ju...
Text Solution
|
Calculate the current through the circuit and the potential difference...
Text Solution
|
Find the currents through the resistances in the circuits shown in fig...
Text Solution
|
Find the currents through the resistances in the circuits shown in fig...
Text Solution
|
A potential barrier V volts exists across a P-N junction. The thicknes...
Text Solution
|
The current flow through the resistance in the given circuit is
Text Solution
|
Consider a p-n junction diode which has a potential drop of 0.5 V whi...
Text Solution
|
The potential barrier of a P-N junction diode is 50 meV, When an elect...
Text Solution
|
In a half wave rectifier circuit operating from 50 Hz mains frequency,...
Text Solution
|
A full-wave rectifier is used to convert 50 Hz A.C into D.C, then the ...
Text Solution
|
The applied a.c power to a full-wave rectifier is 400W. The d.c power ...
Text Solution
|
In a half wave rectifier, a p-n junction diode with internal resistanc...
Text Solution
|
A full wave rectifier circuit along with the output is shown in figure...
Text Solution
|
The equivalent resistance between A and B is
Text Solution
|
In a Germanium diode, the forward current increases from 100mA to 200 ...
Text Solution
|