Home
Class 11
PHYSICS
A wire elongates by l mm when a load W i...

A wire elongates by `l` mm when a load W is hanged from it if the wire goes over a pulley and two weights W each are hung at the two ends the elongation of the wire will be (in mm)

A

0.5 m

B

1.0 mn

C

2.0 mn

D

4.0 mm

Text Solution

Verified by Experts

Promotional Banner

Similar Questions

Explore conceptually related problems

A wire of length L is fixed at one end. It is elongates by I when a load W is hanged from other end. If the wire goes over a pulley and two weights W each are hung at the two ends, the elongation of the wire will be ......

A steel wire of 1.5 m long and of radius 1 mm is attached with a load 3 kg at one end the other end of the wire is fixed it is whirled in a vertical circle with a frequency 2 Hz. Find the elongation of the wire when the weight is at the lowest position Y=2xx10^(11)N//m^(2) and (g=10m//s^(2))

When a load of 5kg is hung on a wire then extension of 30 cm take place then work done will be :-

A wire is hanged from the ceiling without any weight below it, would there any stress in the wire ?

One end of uniform wire of length L and of weight W is attached rigidly to a point in the roof and a weight N is suspended from its lower end if s is the area of cross-section of the wire the stress in the wire at a height (L)/(4) from its lower end is

The graph shown the extension of is wire of length 1 m suspended from the top of a roof at one end and with a load W connected to the other end. If the cross sectional area of the wire is 1 mm^(2) , then the Young's modulus of the material of the wire. ltimg src="https://d10lpgp6xz60nq.cloudfront.net/physics_images/ALN_RACE_R64_E01_001_Q01.png" width="80%"gt

The graph shows the extension of a wire of length 1m suspended from the top of a roof at one end and with a load W connected to the other end. If the cross sectional area of the wire is 1mm^(2) , then the young's modulus of the material of the wire is (a). 2xx10^(11)Nm^(-2) (b). 2xx10^(10)Nm^(-2) (c). (1)/(2)xx10^(11)Nm^(-2) (d). none of these

Figure shows a wire of length 2L and crosssectional area A, stretched horizontally between two clamps. When an object of mass M is suspended from the mid point of the wire, the downward displacement of the young's modulus of the material of the wire is x. Shown that M = (YA x ^(3))/(gL ^(3)) (where theta is small)

The adjacent graph shows the extension (DeltaI) of a wire of length 1 m suspended from the top of a roof at one end with a load W connected to the other end. If the cross-sectional area of the wire is 10^(-6) m ^(2), calculate The Young's modulus of the material of the wire is ........

The adjacent graph shows the estension (Deltal) of a wire of length 1m suspended from the top of a roof at one end and with a load W connected to the other end. If the cross-sectional area of the wire is 10^-6m^2 , calculate the Young's modulus of the material of the wire.