सेट 1 pyq Discussion. लो करलो पूरी तैयारी । [भौकाल PYQ SERIES]

Chapter Explanation|NCERT Discussion|PYQ

Chapter Explanation|NCERT Discussion|PYQ

Chapter Explanation|NCERT Discussion|PYQ

Chapter Explanation|NCERT Discussion|PYQ

Chapter Explanation|NCERT Discussion|PYQ

Chapter Explanation|NCERT Discussion|PYQ

(a) what is the rate at which energy being delivered to a light bulb higher : just after it is turned on , the glow of the filament is increasing , or after it has been on for a few seconds and the glow is steady ? (b) IF a piece of wire is used to connect points b and c in Fig. 7.9, does the brightness of bulb R_(1) increase , decrease or stay constant ? What happens to the brightness of bulb R_(2) ? (I_(1) = I_(2) = I) (c) Compare the brightness of four identical light bulbs in Fig. 7.10 . What happens if the bulb A fails so that it cannot conduct ? What if C fails ? What if D fails? (d) If electric power is transmitted over long distances, the resistance of the wires becomes significant. Why ? Which mode of transmission would result in less energy losss: high current and low voltage or low current and high voltage ? Discuss. (e) In Fig. 7.11 , describe wha happens to the light bulb after the switch is closed . Assume the capacitor has a large capacitance and is initially uncharged. (f) Astuident claims that a second light bulb in series is less bright than the first , because the first bulb uses up some of the current . How would you respond to this statement ? (g) If you were to design an electeric heater using nichrome wire as the heating element , what parameters of the wire would you vary to meet a specific power output , sch as 1000 W ?