A meter bridge is set up is as shown determine as unknown resistance `X` using a standerd `5 ohm` resistor The galvanometer shown nall point when topping key is at `44cm` mark The end corections see `1cm` and `2cm` respectively for the ends `A` and `B` The determine value of `X` is

A meter bridge is set up as shown, to determine an unknown resistance X using a standard 10 ohm resistor. The galvanometer shows null point when tapping -key is at 52 cm mark. The end-corrections are 1 cm and 2 cm respectively for the ends A and B. The determine value of X is

A metrebridge is set-up as shown, to determine an unknown resistance 'X' using a standard 10 ohm resistor. The galvanometer shows null point when tapping-key is at 52 cm mark. The end-corrections are 1 cm and 2 cm respectively for the ends A and B. The determined value of 'X' is

A meter bridge is set-up as shown in figure to determine an unknown resistance X using a standard 10Omega resistor. The galvanometer shown null point when tapping key is at 52 cm mark. The end corrections are 1 cm and 2 cm respectively for the ends A and B. the determined value of X is

A meter bridge is setup as shown in figure, to determine an unknown resistance X using a standard 10Omega resistor. The galvanometer shows null point when tapping key is at 52 cm mark. The end correctiosnn are 1 cm and 2 cm respectively for the ends A and B . The determined value of X is

A meter bridge is setup as shown in figure, to determine an unknown resistance X using a standard 10Omega resistor. The galvanometer shows null point when tapping key is at 52 cm mark. The end correctiosnn are 1 cm and 2 cm respectively for the ends A and B . The determined value of X is

A meter bridge is set- up as shown in figure, to determine an unknown resistance X using a standard 10 Omega resistor. The galvanometer shows null point when tapping - key is at 52 cm mark. The end -corrections are 1 m and 2 cm respectively for the ends A and B . The determined values of X is . (a) 10.2 Omeaga (b) 10.6 Omega (c) 10.8 Omega (d) 11.1 Omega .

A meter bridge is set- up as shown in figure, to determine an unknown resistance X using a standard 10 Omega resistor. The galvanometer shows null point when tapping - key is at 52 cm mark. The end -corrections are 1 m and 2 cm respectively for the ends A and B . The determined values of X is . (a) 10.2 Omeaga (b) 10.6 Omega (c) 10.8 Omega (d) 11.1 Omega .