Home
Class 12
PHYSICS
The power rating of an electric motor th...

The power rating of an electric motor that draws a current of `3.75 A`, when operated at `200 V`, is nearly

A

` 54 W`

B

`1 hp`

C

`500 W`

D

`750 hp`

Text Solution

Verified by Experts

The correct Answer is:
B
`P = 200 xx 3.75 W = 750 W ~~ 1 hp`
Promotional Banner

Topper's Solved these Questions

  • HEATING EFFECT OF CURRENT

    CENGAGE PHYSICS|Exercise Multiple Correct|5 Videos

  • HEATING EFFECT OF CURRENT

    CENGAGE PHYSICS|Exercise Assertion - Reasoning|6 Videos

  • HEATING EFFECT OF CURRENT

    CENGAGE PHYSICS|Exercise Subjective|8 Videos

  • GRAVITATION

    CENGAGE PHYSICS|Exercise Question Bank|39 Videos

  • INDUCTANCE

    CENGAGE PHYSICS|Exercise Concept Based|9 Videos

Similar Questions

Explore conceptually related problems

The resistance of the armature of an electric motor is 55 ohm. The motor draw a current of 2 A when running at 220 V. What is the back e.m.f ?

The armature of a DC motor has 20Omega resistance. It draws a current of 1.5 A when run by 200 V DC supply The value of back emf induced in it will be

When an electric lamp is connected to 12V battery, it draws a current of 0.5A. The power of the lamp is:

The potential difference between the terminals of an electric heater is 60 V when it draws a current of 4 A from the 3 source. What current will the heater draw if the potential difference is increased to 172.5 V?

Calculate the current through a lamp of 25 W operating at 200 V .

CENGAGE PHYSICS-HEATING EFFECT OF CURRENT-Single Correct
  1. How many calories of heat will be approximately developed in a 210 W e...

    Text Solution

    |

  2. A constant voltage is applied between the two ends of a metallic wire ...

    Text Solution

    |

  3. The power rating of an electric motor that draws a current of 3.75 A, ...

    Text Solution

    |

  4. A cable of resistance 10 Omega carries electric power from a generator...

    Text Solution

    |

  5. In the previous problem , the power lost in the cable during transmiss...

    Text Solution

    |

  6. The heat generated through 4 Omega and 9 Omega resistances separately ...

    Text Solution

    |

  7. If the length of the filament of a heater is reduced by 10%, the power...

    Text Solution

    |

  8. A 2k W heater used for 1 h every day consumes the following electrica...

    Text Solution

    |

  9. Two cells , each of emf E and internal resistance r, are connected in ...

    Text Solution

    |

  10. A constant voltage is applied between the two ends of a uniform metall...

    Text Solution

    |

  11. A given resistor cannot carry currents exceeding 20 A, without exceedi...

    Text Solution

    |

  12. A wire when connected to 220 V mains supply has power dissipation P1. ...

    Text Solution

    |

  13. A 220 volt, 1000 watt bulb is connected across a 110 volt mains supply...

    Text Solution

    |

  14. A heater coil is cut into two equal parts and only one part is now use...

    Text Solution

    |

  15. Three 10 Omega , 2 W resistors are connected as in Fig. 7.34. The maxi...

    Text Solution

    |

  16. A torch bulb rated 4.5 W, 1.5 V is connected as shown in Fig. 7.35. Th...

    Text Solution

    |

  17. A heater is designed to operate with a power of 1000W in a 100 V line....

    Text Solution

    |

  18. The supply voltage to room is 120 V. The resistance of the lead wires ...

    Text Solution

    |

  19. Figure 7.37 shows a network of three resistances. When some potential...

    Text Solution

    |

  20. Resistors P , Q , and R in the circuit have equal resistances. If the ...

    Text Solution

    |