Home
Class 12
PHYSICS
In the previous problem , the power lost...

In the previous problem , the power lost in the cable during transmission is

A

`3.15 kW`

B

`12.5 kW`

C

`6.25 kW`

D

`25 kW`

Text Solution

Verified by Experts

The correct Answer is:
C
power lost `= 25 xx 25 xx 10 W = 6250 W = 6.25 kW`
Promotional Banner

Topper's Solved these Questions

  • HEATING EFFECT OF CURRENT

    CENGAGE PHYSICS|Exercise Multiple Correct|5 Videos

  • HEATING EFFECT OF CURRENT

    CENGAGE PHYSICS|Exercise Assertion - Reasoning|6 Videos

  • HEATING EFFECT OF CURRENT

    CENGAGE PHYSICS|Exercise Subjective|8 Videos

  • GRAVITATION

    CENGAGE PHYSICS|Exercise Question Bank|39 Videos

  • INDUCTANCE

    CENGAGE PHYSICS|Exercise Concept Based|9 Videos

Similar Questions

Explore conceptually related problems

In the previous problem, the velocity of the shell will be

In the previous problem, what is the salary of the clerk?

In the previous problem , the maximum elongation of the spring is

In the previous problem, the velocity of projection is

In the previous problem, What is the angle of projection ?

CENGAGE PHYSICS-HEATING EFFECT OF CURRENT-Single Correct
  1. The power rating of an electric motor that draws a current of 3.75 A, ...

    Text Solution

    |

  2. A cable of resistance 10 Omega carries electric power from a generator...

    Text Solution

    |

  3. In the previous problem , the power lost in the cable during transmiss...

    Text Solution

    |

  4. The heat generated through 4 Omega and 9 Omega resistances separately ...

    Text Solution

    |

  5. If the length of the filament of a heater is reduced by 10%, the power...

    Text Solution

    |

  6. A 2k W heater used for 1 h every day consumes the following electrica...

    Text Solution

    |

  7. Two cells , each of emf E and internal resistance r, are connected in ...

    Text Solution

    |

  8. A constant voltage is applied between the two ends of a uniform metall...

    Text Solution

    |

  9. A given resistor cannot carry currents exceeding 20 A, without exceedi...

    Text Solution

    |

  10. A wire when connected to 220 V mains supply has power dissipation P1. ...

    Text Solution

    |

  11. A 220 volt, 1000 watt bulb is connected across a 110 volt mains supply...

    Text Solution

    |

  12. A heater coil is cut into two equal parts and only one part is now use...

    Text Solution

    |

  13. Three 10 Omega , 2 W resistors are connected as in Fig. 7.34. The maxi...

    Text Solution

    |

  14. A torch bulb rated 4.5 W, 1.5 V is connected as shown in Fig. 7.35. Th...

    Text Solution

    |

  15. A heater is designed to operate with a power of 1000W in a 100 V line....

    Text Solution

    |

  16. The supply voltage to room is 120 V. The resistance of the lead wires ...

    Text Solution

    |

  17. Figure 7.37 shows a network of three resistances. When some potential...

    Text Solution

    |

  18. Resistors P , Q , and R in the circuit have equal resistances. If the ...

    Text Solution

    |

  19. Three bulbs of 40 W , 60 W and 100 W are connected in series with a 24...

    Text Solution

    |

  20. In the circuit shown in fig the heat produced in the 5 ohm resistor du...

    Text Solution

    |