Home
Class 12
PHYSICS
The current in C is 2 A. The rate of hea...

The current in `C` is `2 A`. The rate of heat of loss in `A,B` and `C are 1.20, 0.60 and `1.20 J//sec respectively. The emf of the cell [for cell internal resistance = 0] is

A

`3 V`

B

`1.5 V`

C

`3.6 V`

D

None

Text Solution

Verified by Experts

The correct Answer is:
B
(b) Power `= EI`
`implies (1.20 + 0.60 + 1.20) = E xx 2 implies E = 1.5 V`
Promotional Banner

Topper's Solved these Questions

  • CURRENT ELECTRICITY

    A2Z|Exercise Problems Based On Mixed Concepts|34 Videos

  • CURRENT ELECTRICITY

    A2Z|Exercise Section - A|1 Videos

  • CURRENT ELECTRICITY

    A2Z|Exercise Potentiometer And Meter Bridge|45 Videos

  • ATOMIC PHYSICS

    A2Z|Exercise Section D - Chapter End Test|30 Videos

  • DUAL NATURE OF RADIATION AND MATTER

    A2Z|Exercise Section D - Chapter End Test|30 Videos

Similar Questions

Explore conceptually related problems

The resistance of the four arms A, B, C and D of a wheatstone bridge as shown in the figure are 10 Omega , 20 Omega , 30 Omega and 60 Omega respectively . The emf and internal resistance of the cell are 15 V and 2.5 Omega respectively . If the galvanometer resistance is 80 Omega then the net current drawn from the cell will be

A cell to emf. E and internal resistance r supplies currents for the same time t through external resistance R_1 and R_2 respectively. If the heat produced in both cases is the same, then the internal resistance is given by :

(a) Three cells of emfs, 1.5 V, 2.0V and 2.5 V are connected in series. Their internal resistance are 0.20 Omega, 0.15 Omega and 0.15 Omega respectively. The battery is connected to an external resistor of 5.5 Omega via a very low resistance ammeter, what would be the reading of ammeter? (b) If the three cells above were joined in parallel, would they be characterised by a definite emf and internal resistance (independent of their individual internal resistance )? If not, how will you obtain currents in different branches of the circuit ?

Three cells of emf 2.0 v, 1.8 V and 1.5 V are connected in series. Their internal resistances are 0.05 Omega, 0.7 Omega " and " 1 Omega respectively. If the battery is connected to an external resistor of 4 Omega via a very resistance ammeter, what would be the reading in the ammeter ?

Three cells each of emf 1.5 V, after being connected in series with each other, are connected to the ends of a resistance. The current obtained is 1 A. When the cells are connected in parallel across the ends of the same resistance, the current is found to be 0.36 A. Find the external resistance and the internal resistance of each cell.

A cell of emf epsilon and internal resistance r is charged by a current I, then

The emf of a cell is 2 V. When the terminals of the cell is connected to a resistance 4Omega . The potential difference across the terminals, if internal resistance of cell is 1Omega is

The pd across terminals of a cell is found to be 29 volt and 28 volt respectively when it delivers a current of 1 ampere and 2 ampere respectively. The emf and internal resistance of a cell are respectively

In the ciruit the cells E_1 and E_2 have emfs of 4V and 8V and internal resistance 0.5 Omega and 1.0 Omega, respectively. Calculate the current through 6 Omega resistance. ltBrgt

A2Z-CURRENT ELECTRICITY-Heating Effect Of Current
  1. What will happen when a 40 watt 220 volt lamp and 100 watt-220 volt la...

    Text Solution

    |

  2. What should be the value of resistance R in the circuit shown in figur...

    Text Solution

    |

  3. The current in C is 2 A. The rate of heat of loss in A,B and C are 1.2...

    Text Solution

    |

  4. If the length of the filament of a heater is reduced by 10%, the power...

    Text Solution

    |

  5. Two wire A and B of same meterial and mass have their lengths in the r...

    Text Solution

    |

  6. Two bulbs X and Y having same voltage rating and of power 40 watt and ...

    Text Solution

    |

  7. In an electric circuit shown in the figure. The external resistance R ...

    Text Solution

    |

  8. The resistance of the filament of an electric bulb changes with temper...

    Text Solution

    |

  9. In the circuit shown in fig the heat produced in the 5 ohm resistor du...

    Text Solution

    |

  10. Water boils in an electric kettle in 15 minutes after switching on. If...

    Text Solution

    |

  11. The resistance of a heater coil is 110 ohm. A resistance R is connecte...

    Text Solution

    |

  12. An electric kettle takes 4 A current at 220 V. How much time will it t...

    Text Solution

    |

  13. Four identical electrical lamps are labelled 1.5 V, 0.5 A which descri...

    Text Solution

    |

  14. A 100 W bulb B1, and two 60 W bulbs B2 and B3 are connected to a 250 ...

    Text Solution

    |

  15. An electric bulb rated for 500 W at 100 V is used in a circuit having ...

    Text Solution

    |

  16. The wiring of a house has resistance 6 Omega A 100 W bulb is glowing. ...

    Text Solution

    |

  17. Electric bulb 50 W - 100 V glowing at full power are to be used in par...

    Text Solution

    |

  18. If a 30 V, 90 W bulb is to be worked on a 120 V line, resistance of h...

    Text Solution

    |

  19. For ensuring dissipation of same energy in all three resistors (R(1), ...

    Text Solution

    |

  20. Battery shown in figure has e.m.f. E and internal resistance r. Curren...

    Text Solution

    |