Home
Class 12
PHYSICS
If an ammeter is to be used in place of ...

If an ammeter is to be used in place of a voltmeter, then we must connect with the ammeter a

A

Low resistance in parallel

B

High resistance in parallel

C

High resistance in series

D

Low resistance in series

Text Solution

Verified by Experts

The correct Answer is:
C
(c )If ammeter is used in place of voltemter (i.e., in parallel) it may damage due to large current in circuit. Hence, to control this large this large amount of current a high resistance must be connected in series.
Promotional Banner

Topper's Solved these Questions

  • CURRENT ELECTRICITY

    A2Z|Exercise Assertion- Reason|14 Videos

  • ATOMIC PHYSICS

    A2Z|Exercise Section D - Chapter End Test|30 Videos

  • DUAL NATURE OF RADIATION AND MATTER

    A2Z|Exercise Section D - Chapter End Test|30 Videos

Similar Questions

Explore conceptually related problems

A voltmeter can be converted into ammeter by connecting

An ammeter can be converted into voltmeter by connecting

In ac circuit when ac ammeter is connected it reads i current if a student used dc ammeter in place of ac ammeter the reading in the dc ammeter will be:

To increase the range of an ammeter, we need to connect a suitable

Which statement/statement is/are correct? 1. An ammeter is connected in series in a circuit and a voltmeter is connected in parallel. 2. An ammeter has a high resistance. 3. A voltmeter has a low resistance.

Assertion : An ammeter is always connected in series whereas a voltmeter is connected in parallel. Reason : An ammeter is a low-resistance galvanometer while a voltmeter is high resistance galvanometer.

A2Z-CURRENT ELECTRICITY-Section D - Chapter End Test
  1. If an ammeter is to be used in place of a voltmeter, then we must conn...

    Text Solution

    |

  2. An ammeter reads up to 1 ampere. Its internal resistance is 0.81 ohm. ...

    Text Solution

    |

  3. The length of a wire of a potentiometer is 100 cm, and the e.m.f. of i...

    Text Solution

    |

  4. A piece of copper and another of germanium are cooled from room temper...

    Text Solution

    |

  5. The length of a given cylindrical wire is increased by 100%. Due to th...

    Text Solution

    |

  6. The resistance of the series combination of two resistances is S. When...

    Text Solution

    |

  7. The total current supplied to the circuit by the battery is

    Text Solution

    |

  8. Two sources of equal emf are connected to an external resistance R. Th...

    Text Solution

    |

  9. An energy source will supply a constant current into the load if its i...

    Text Solution

    |

  10. In a potentiometer experiment the balancing with a cell is at length 2...

    Text Solution

    |

  11. A moving coil galvanometer has 150 equal divisions. Its current sensit...

    Text Solution

    |

  12. The current from the battery in circuit diagram shown is

    Text Solution

    |

  13. A battery of internal resistance 4Omega is connected to the network of...

    Text Solution

    |

  14. A Steady current flows in a metalic conductor of non uniform cross sec...

    Text Solution

    |

  15. In the circuit shown in figure the current through

    Text Solution

    |

  16. A wire of length L and 3 identical cells of negligible internal resist...

    Text Solution

    |

  17. Express which of the following set ups can be used to verify ohm's l...

    Text Solution

    |

  18. Six identical resistors are connected as shown in the figure. The equi...

    Text Solution

    |

  19. A wire when connected to 220 V mains supply has power dissipation P1. ...

    Text Solution

    |

  20. A heater coil is cut into two equal parts and only one part is now use...

    Text Solution

    |