Home
Class 12
PHYSICS
A meter bridge is set up as shown, to de...

A meter bridge is set up as shown, to determine an unknown resistance `X` using a standard 10 ohm resistor. The galvanometer shows null point when tapping -key is at 52 cm mark. The end-corrections are 1 cm and 2 cm respectively for the ends A and B. The determine value of `X` is

A

`10.2 ohm`

B

`10.6 ohm`

C

`10.8 ohm`

D

`11.1 ohm`

Text Solution

Verified by Experts

The correct Answer is:
B
`X(48+2)=(10)(52+1)`
`X=(530)/(50)=10.6Omega`
Promotional Banner

Topper's Solved these Questions

  • EXPERIMENTAL PHYSICS

    NARAYNA|Exercise Comprehension type|6 Videos

  • EXPERIMENTAL PHYSICS

    NARAYNA|Exercise Subjective type|6 Videos

  • ELECTROSTATICS AND GAUSS LAW

    NARAYNA|Exercise Intergers type question|11 Videos

  • MAGNETISM

    NARAYNA|Exercise LEVEL-II (H.W)|24 Videos

Similar Questions

Explore conceptually related problems

A meter bridge is set-up as shown in figure to determine an unknown resistance X using a standard 10Omega resistor. The galvanometer shown null point when tapping key is at 52 cm mark. The end corrections are 1 cm and 2 cm respectively for the ends A and B. the determined value of X is

A meter bridge is setup as shown in figure, to determine an unknown resistance X using a standard 10Omega resistor. The galvanometer shows null point when tapping key is at 52 cm mark. The end correctiosnn are 1 cm and 2 cm respectively for the ends A and B . The determined value of X is

A meter bridge is set- up as shown in figure, to determine an unknown resistance X using a standard 10 Omega resistor. The galvanometer shows null point when tapping - key is at 52 cm mark. The end -corrections are 1 m and 2 cm respectively for the ends A and B . The determined values of X is . (a) 10.2 Omeaga (b) 10.6 Omega (c) 10.8 Omega (d) 11.1 Omega .

A meter bridge is set up is as shown determine as unknown resistance X using a standerd 5 ohm resistor The galvanometer shown nall point when topping key is at 44cm mark The end corections see 1cm and 2cm respectively for the ends A and B The determine value of X is

In a meter bridge experiment shown below, the null point is obtained at P. The value of unknown resistance X is 2012 50 cm 1.) E

A uniform wire AB of length 1 m, an unknown resistance X and a resistance of 12 Omega are connected to a battery and a galvanometer G as shown in the figure. The galvanometer shows no deflection when AJ=60 cm. What is the value of X (in ohm) ?

In the metre-bridge experiment with uknown resistance X in the left gap and a known resistance of 60Omega in the right gap, null point is obtained at l cm from left. If the unknown resistance X is shunted by an equal resistance, what should be the value of the known resistance in the right gap in order to get the null point at the same position?.

An unknown resistance is placed in the left gap and resistance of 50 ohm is placed in the right gap of a meter bridge . The null point is obtained at 40 cm from the left end. Determine the unknown resistance.

In a meter bridge, null point is 20 cm , when the known resistance R is shunted by 10 Omega resistance, null point is found to be shifted by 10 cm. Find the unknown resistance X .

NARAYNA-EXPERIMENTAL PHYSICS-Level-VI(Single answer)
  1. If we use very thin and long wire, then

    Text Solution

    |

  2. If accidentally the calorimeter remained open to atmosphere was for so...

    Text Solution

    |

  3. If a tuning fork of frequency (340 pm 1 %) is used in the resonance tu...

    Text Solution

    |

  4. If emf of battery is 100V, then what was the resistance of Rheostat ad...

    Text Solution

    |

  5. I v//s V curve for a non Ohmic resistance is shown. The dynamic resist...

    Text Solution

    |

  6. If by mistake Ammeter is connected parallel to the resistance then i-V...

    Text Solution

    |

  7. If by mistake Ammeter is connected parallel to the resistance then i-V...

    Text Solution

    |

  8. In the experiment of Ohm's law, when potential difference of 10.0 V is...

    Text Solution

    |

  9. From some instruments current measured is I=10.0amp, potential differe...

    Text Solution

    |

  10. In the previous question, maximum permissible error is resitivity and ...

    Text Solution

    |

  11. If resistance S in RB=300Omega, then the balanced length is found to b...

    Text Solution

    |

  12. In the previous question, if R and S are interchanged, balanced point ...

    Text Solution

    |

  13. In a meter bridge, null point is at l=33.7cm, when the resistance S is...

    Text Solution

    |

  14. In u-v method to find focal length of a concave mirror, if object dist...

    Text Solution

    |

  15. To verify Ohm's law, a student is provided with a test resistor R(T), ...

    Text Solution

    |

  16. A vernier calipers has 1mm marks on the main scale. It has 20 equal di...

    Text Solution

    |

  17. A meter bridge is set up as shown, to determine an unknown resistance ...

    Text Solution

    |

  18. The density of a solid ball is to be determined in an experiment. The ...

    Text Solution

    |

  19. In the determination if Young's modulus ((Y = (4MLg)/(pild^(2)) by usi...

    Text Solution

    |

  20. A student is performing the experiment of resonance column. The diamet...

    Text Solution

    |