Home
Class 12
PHYSICS
In the diagram, the input is across the ...

In the diagram, the input is across the terminals `A` and `C` and the output is across the terminals `B` and `D`, then the outputs is

A

Zero

B

Same as the input

C

Full wave rectified

D

Half-wave rectified

Text Solution

Verified by Experts

The correct Answer is:
C
The given question is based on Bridge Rectifier. This is the most widely used full-wave rectifier. It makes use of four diodes `D_(1),D_(2),D_(3),D_(4)` connected in the four arms of a bridge. Bridge rectifier does not require a centre-tapped transformer.
Promotional Banner

Topper's Solved these Questions

  • SEMI CONDUCTOR DEVICES

    NARAYNA|Exercise Level-III (C.W)|20 Videos

  • SEMI CONDUCTOR DEVICES

    NARAYNA|Exercise NCERT (Comprehension)|13 Videos

  • SEMI CONDUCTOR DEVICES

    NARAYNA|Exercise Level-I (C.W)|21 Videos

  • RAY OPTICS AND OPTICAL INSTRAUMENTS

    NARAYNA|Exercise EXERCISE- 4 One or more than one correct answer type|13 Videos

  • SEMICONDUCTOR ELECTRONICS

    NARAYNA|Exercise ADDITIONAL EXERCISE (ASSERTION AND REASON TYPE QUESTIONS :)|19 Videos

Similar Questions

Explore conceptually related problems

In the figure, the input is across the terminals A and C and the output is across B and D. Then the output is (a ) zero ( b) same as the input ( c) full - wave rectified (d) half - wave rectified .

In the diagram resistance across terminals A and B is

Draw the output wave form across the resistor

Potential difference across the terminal of a non ideal battery is

The equivalent capacitance of the circuit across the terminals (A )and (B) is equal to .

Draw the output waveform across the resistor (Fig.)

Find the equivalent capacitance across terminals A and B in the circuit shown in figure.

When the inputs of a two input logic gate are 0 and 0, the output is 1. When the inputs are 1 and 0, the output is zero. The type of logic gate is

NARAYNA-SEMI CONDUCTOR DEVICES-Level-II (C.W)
  1. A junction diode is connected to a 10 V source and 10^(3) Omega rheost...

    Text Solution

    |

  2. A p-n junction (D) shown in the figure can act as a rectifier. An alte...

    Text Solution

    |

  3. In the diagram, the input is across the terminals A and C and the outp...

    Text Solution

    |

  4. The I-V characteristic of an LED is.

    Text Solution

    |

  5. In the circuit shown. The potential drop across each capacitor is (ass...

    Text Solution

    |

  6. The maximum and minimum values of zener diode current are

    Text Solution

    |

  7. In an n-p-n transistor circuit, the collector current ia 10 mA. If 90%...

    Text Solution

    |

  8. The constant alpha of a transistor is 0.9 What would be the change in ...

    Text Solution

    |

  9. A voltage amplifier operated from a 12 volt battery has a collector lo...

    Text Solution

    |

  10. In a transistor circuit shown here the base current is 35 muA. The val...

    Text Solution

    |

  11. In a single state transistor amplifier, when the signal changes by 0.0...

    Text Solution

    |

  12. On subtracting 010101 from 101010, we get :

    Text Solution

    |

  13. The minimum number of gates required to realise this expression Z = DA...

    Text Solution

    |

  14. In the circuit below, A and B represents two inputs and C represents t...

    Text Solution

    |

  15. In the following circuit the output Y becomes zero for the inputs .

    Text Solution

    |

  16. The combination of gates shown below yields .

    Text Solution

    |

  17. The logic gate having an output of 1 is. (i)

    Text Solution

    |

  18. In a given circuit as shown the two input wave forms A and B are appli...

    Text Solution

    |

  19. The output of the combination of the gates shown in the figure below i...

    Text Solution

    |

  20. The expression of Y in following circuit is .

    Text Solution

    |